[PATCH v9 3/3] gpio: nuvoton: Add Nuvoton NPCM sgpio driver

[Jim Liu]

Hi  Andy

Thanks for your reply.
The description as below


> > > +     in_port = GPIO_BANK(gpio->nin_sgpio);
> > > +     if (GPIO_BIT(gpio->nin_sgpio) > 0)
> > > +             in_port += 1;
> >
> > This is strange... So, you are telling that offsets start from 1 and not 0?
> >
> > > +     out_port = GPIO_BANK(gpio->nout_sgpio);
> > > +     if (GPIO_BIT(gpio->nout_sgpio) > 0)
> > > +             out_port += 1;
> >
> > Ditto.
> >
> Yes,  if the customer has defined the in/out pins the offsets start from 1.

>Why?

The NPCM_IOXCFG2_PORT  default setting is to enable 0 input port and 0
output port.
The register default value is 0x0. Each port can support 8 pins.
If the register value is 0x31 means enable 3 output ports and 1 input port.
If customer has define nuvoton,input-ngpios  or  nuvoton,output-ngpios
dts property

For example , nuvoton,output-ngpios = <9>
> > > +     out_port = GPIO_BANK(gpio->nout_sgpio);
The out_port value is 1 but one port only supports 8 pins.
> > > +     if (GPIO_BIT(gpio->nout_sgpio) > 0)
> > > +             out_port += 1;
This out_port value is 2, the driver will enable two port to support 9 pins.

Maybe it is my expression error , the out_port and in_port default value is 0.


> The NPCM_IOXCFG2_PORT register is the set number of in/out ports.
> NPCM_IOXCFG2_PORT register define as below:
> 0~3 bit is the number of input ports
> 4~7 bit is the number of output ports
> Each module can support 8 input ports and 8 output ports.

Best regards,
Jim