[PATCH v2 3/5] hw: aspeed: Ensure AST1030 respects uart-default

[Peter Delevoryas]

The AST1030 machine initialization was not respecting the Aspeed SoC
property "uart-default", which specifies which UART should be connected to
the first serial device, it was just always connecting UART5. This doesn't
change any behavior, because the default value for "uart-default" is UART5,
but it makes it possible to override this in new machine definitions using
the AST1030.

Signed-off-by: Peter Delevoryas <pdel at fb.com>
---
 hw/arm/aspeed_ast10x0.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/hw/arm/aspeed_ast10x0.c b/hw/arm/aspeed_ast10x0.c
index bb8177e86c..faafb800f3 100644
--- a/hw/arm/aspeed_ast10x0.c
+++ b/hw/arm/aspeed_ast10x0.c
@@ -215,9 +215,9 @@ static void aspeed_soc_ast1030_realize(DeviceState *dev_soc, Error **errp)
                        qdev_get_gpio_in(DEVICE(&s->armv7m),
                                 sc->irqmap[ASPEED_DEV_KCS] + aspeed_lpc_kcs_4));
 
-    /* UART5 - attach an 8250 to the IO space as our UART */
-    serial_mm_init(get_system_memory(), sc->memmap[ASPEED_DEV_UART5], 2,
-                   aspeed_soc_get_irq(s, ASPEED_DEV_UART5),
+    /* UART - attach an 8250 to the IO space as our UART */
+    serial_mm_init(get_system_memory(), sc->memmap[s->uart_default], 2,
+                   aspeed_soc_get_irq(s, s->uart_default),
                    38400, serial_hd(0), DEVICE_LITTLE_ENDIAN);
 
     /* Timer */
-- 
2.30.2