[PATCH v4 8/9] i2c: npcm: Remove own slave addresses 2:10

[Tyrone Ting]

Hi Andy:

I would like to have your comments about the "Fancy indentation"
because I'm not sure if I get the point.

I remove extra empty lines and reformat the commit message.

Please see the details below.

Thank you.

Tyrone Ting <warp5tw at gmail.com> 於 2022年5月11日 週三 上午9:39寫道：
>
> Hi Andy:
>
> Thank you for your comments and they will be addressed.
>
> Andy Shevchenko <andriy.shevchenko at linux.intel.com> 於 2022年5月10日 週二 下午6:19寫道：
> >
> > On Tue, May 10, 2022 at 05:16:53PM +0800, Tyrone Ting wrote:
> > > From: Tali Perry <tali.perry1 at gmail.com>
> > >
> > > NPCM can support up to 10 own slave addresses.
> > > In practice, only one address is actually being used.
> > > In order to access addresses 2 and above, need to switch
> > > register banks. The switch needs spinlock.
> > > To avoid using spinlock for this useless feature
> > > removed support of SA >= 2.
> >
> > > Also fix returned slave event enum.
> > >
> > > Remove some comment since the bank selection is not
> > > required. The bank selection is not required since
> > > the supported slave addresses are reduced.
> >
> > Fancy indentation. Please fix it in all your commit messages where it applies.
> >

I modify the commit message as following:

NPCM can support up to 10 own slave addresses. In practice, only one
address is actually being used. In order to access addresses 2 and above,
need to switch register banks. The switch needs spinlock.
To avoid using spinlock for this useless feature removed support of SA >=
2. Also fix returned slave event enum.

Remove some comment since the bank selection is not required. The bank
selection is not required since the supported slave addresses are reduced.

> > ...
> >
> > > +     if (addr_type > I2C_SLAVE_ADDR2 && addr_type <= I2C_SLAVE_ADDR10) {
> > > +             dev_err(bus->dev,
> > > +                     "try to enable more then 2 SA not supported\n");
> >
> > Make it one line and drop {}.
> >
> > > +     }
> >
> > ...
> >
> > > +     if (addr_type > I2C_SLAVE_ADDR2 && addr_type <= I2C_SLAVE_ADDR10) {
> > > +             dev_err(bus->dev,
> > > +                     "get slave: try to use more then 2 slave addresses not supported\n");
> >
> > As per above be consistent with abbreviations ("SA" here, which makes line
> > shorter) and follow the above recommendation.
> >
> > > +     }
> >
> > --
> > With Best Regards,
> > Andy Shevchenko
> >
> >
>
> Best Regards,
> Tyrone

Best Regards,
Tyrone