OpenBMC Network Route Management: Metric and Static Route config support

[raviteja bailapudi]

Hi Team

We have hit network routing issues while using Static IPv4 addresses on
both eth0 and eth1,  as both default gateways at the interfaces were of the
same metric value. To solve this problem we are planning to provide an
interface for admins to set the metric value for the gateway while setting
up the Static IPv4 network on BMC.


To enable users to connect from outside-subnet clients, we also need to
support static routes on BMC.


I have started a thread in redfish forum as well

https://redfishforum.com/thread/683/network-routing-table-management-support


Please share your views on the same.



Regards,

Raviteja
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ozlabs.org/pipermail/openbmc/attachments/20220622/1384c55e/attachment.htm>