[RESEND][PATCH u-boot v2019.04-aspeed-openbmc v5 1/2] arm/dts: Add IBM Genesis3 board

[Patrick Rudolph]

Hi Andrew,
the first and second version of this patch were including ast2500.dtsi
and enabled the devices.
Joel and Zev recommended including the EVB dts to have less copy&paste code.

Please advise how to continue. Both versions are working and have been
send to the ML.

Regards,
Patrick


On Thu, Aug 11, 2022 at 8:17 AM Andrew Jeffery <andrew at aj.id.au> wrote:
>
>
>
> On Thu, 11 Aug 2022, at 15:30, Patrick Rudolph wrote:
> > There's no SD card slot, there are two MACs in RGMII mode and nothing
> > that's required to boot on i2c bus.
> > In the defconfig used I disabled SD card and I2C support, so this is
> > not an issue.
> > Should I still disable it in the devicetree, just for reference?
>
> It's at least more idiomatic to `#include "ast2500.dtsi"` and then
> enable the controllers you require, rather than #including the dts for a
> board not entirely related to the design you're bringing up.
>
> That would be my preference. Is the result much more verbose? It feels
> like it shouldn't be if you only need networking and SPI flash.
>
> Andrew