[PATCH v5 2/2] clocksource/drivers/npcm: Add NPCM7xx timer driver

[Tomer Maimon]

On 8 March 2018 at 17:33, Daniel Lezcano <daniel.lezcano at linaro.org> wrote:
> On 08/03/2018 16:24, Tomer Maimon wrote:
>> Add Nuvoton BMC NPCM7xx timer driver.
>>
>> The clocksource Enable 24-bit TIMER0 and TIMER1 counters,
>> while TIMER0 serve as clockevent and TIMER1 serve as clocksource.
>>
>> Signed-off-by: Tomer Maimon <tmaimon77 at gmail.com>
>> Reviewed-by: Brendan Higgins <brendanhiggins at xxxxxxxxxx>
>> ---
>
> [ ... ]
>
>> +
>> +     pr_info("Enabling NPCM7xx clocksource timer base: 0x%x, IRQ: %d ",
>> +             (int)timer_of_base(&npcm7xx_to), timer_of_irq(&npcm7xx_to));
>
> You can use '%p' instead of '0x%x' and remove the (int) cast.
I think we need to use in the pr_info %px, if I use %p I get in the
kernel boot print "(ptrval)" instead of the address.
please refer: https://lwn.net/Articles/740249/
>
> I'm fine with the driver. If there is no comment, I will take it and do
> the change (if you are ok), no need on this case to resend a v6.
Yes great, Thank a lot!
>
>
>
> --
>  <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs
>
> Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
> <http://twitter.com/#!/linaroorg> Twitter |
> <http://www.linaro.org/linaro-blog/> Blog
>