[PATCH v2 2/2] hwmon: npcm750: add NPCM7xx PWM and Fan driver

[Guenter Roeck]

On Wed, Jun 20, 2018 at 11:25:08AM -0700, Joe Perches wrote:
> (adding Julia Lawall and cocci mailing list)
> 
> On Wed, 2018-06-20 at 09:48 -0700, Guenter Roeck wrote:
> []
> > > +static inline void npcm7xx_fan_start_capture(struct npcm7xx_pwm_fan_data *data,
> > > +						 u8 fan, u8 cmp)
> > > +{
> > > +	u8 fan_id = 0;
> > > +	u8 reg_mode = 0;
> > > +	u8 reg_int = 0;
> > > +	unsigned long flags;
> > > +
> > > +	fan_id = NPCM7XX_FAN_INPUT(fan, cmp);
> > > +
> > > +	/* to check whether any fan tach is enable */
> > > +	if (data->npcm7xx_fan[fan_id].FanStFlag != FAN_DISABLE) {
> > > +		/* reset status */
> > > +		spin_lock_irqsave(&data->npcm7xx_fan_lock[fan], flags);
> > > +
> > > +		data->npcm7xx_fan[fan_id].FanStFlag = FAN_INIT;
> > > +		reg_int = ioread8(NPCM7XX_FAN_REG_TIEN(data->fan_base, fan));
> > > +
> > > +		if (cmp == NPCM7XX_FAN_CMPA) {
> > > +			/* enable interrupt */
> > > +			iowrite8((u8) (reg_int | (NPCM7XX_FAN_TIEN_TAIEN |
> > > +						  NPCM7XX_FAN_TIEN_TEIEN)),
> > 
> > Is the (u8) typecast really necessary ? Seems unlikely.
> 
> The cast is not really necessary here as there would
> be an implicit cast already.
> 
> Some might complain about loss of type safety and
> "make W=123" would probably emit something here.
> 
I spent (wasted) some time browsing through the kernel.
Similar typecasts are only used if there is a real type change.
A warning here would not make sense unless NPCM7XX_FAN_TIEN_TAIEN
or NPCM7XX_FAN_TIEN_TEIEN would be outside the u8 range, and then
there would be one anyway.

So, no, I am not going to accept those typecasts. They just make the code
more difficult to read. For example, the code here could have been
simplified to something like

	reg_int = ioread8(NPCM7XX_FAN_REG_TIEN(data->fan_base, fan));
	reg_mode = ioread8(NPCM7XX_FAN_REG_TCKC(data->fan_base, fan));
	if (cmp == NPCM7XX_FAN_CMPA) {
		reg_int |= NPCM7XX_FAN_TIEN_TAIEN | NPCM7XX_FAN_TIEN_TEIEN;
		reg_mode |= NPCM7XX_FAN_TCKC_CLK1_APB;
	} else {
		reg_int |= NPCM7XX_FAN_TIEN_TBIEN | NPCM7XX_FAN_TIEN_TFIEN;
		reg_mode |= NPCM7XX_FAN_TCKC_CLK2_APB;
	}
	iowrite8(reg_int, NPCM7XX_FAN_REG_TIEN(data->fan_base, fan);
	iowrite8(reg_mode, NPCM7XX_FAN_REG_TCKC(data->fan_base, fan);

This, in turn, leads to the question if it is really not necessary
to _clear_ those mask bits in the same context.

Guenter

> But casts to the same type are not necessary.
> 
> A possible coccinelle script to find casts to the
> same type is below, but there are some false positives
> for things like __force and __user casts
> 
> Also, spatch (1.0.4) seems to have a defect for this
> when the type is used in operations that change a
> smaller type to int or unsigned int.
> 
> i.e.: (offset is u16, but offset * 2 is int)
> 
> While running the cocci script below:
> 
> HANDLING: drivers/net/ethernet/intel/igb/e1000_nvm.c
> diff = 
> diff -u -p a/drivers/net/drivers/net/ethernet/intel/igb/e1000_nvm.c b/drivers/net/ethernet/intel/igb/e1000_nvm.c
> --- a/drivers/net/ethernet/intel/igb/e1000_nvm.c
> +++ b/drivers/net/ethernet/intel/igb/e1000_nvm.c
> @@ -335,7 +335,7 @@ s32 igb_read_nvm_spi(struct e1000_hw *hw
>  
>  	/* Send the READ command (opcode + addr) */
>  	igb_shift_out_eec_bits(hw, read_opcode, nvm->opcode_bits);
> -	igb_shift_out_eec_bits(hw, (u16)(offset*2), nvm->address_bits);
> +	igb_shift_out_eec_bits(hw, (offset * 2), nvm->address_bits);
>  
>  	/* Read the data.  SPI NVMs increment the address with each byte
>  	 * read and will roll over if reading beyond the end.  This allows
> 
> ---
> 
> Anyway, here's the cocci script:
> 
> $ cat same_typecast.cocci
> @@
> type T;
> T foo;
> @@
> 
> -	(T *)&foo
> +	&foo
> 
> @@
> type T;
> T foo;
> @@
> 
> -	(T)foo
> +	foo
>