Temperature Sensor and its Reading not Showing Up.

[Emily Shaffer]

Akash,

Check out this doc:
https://github.com/openbmc/docs/blob/master/sensor-architecture.md

Basically, you need your sensors to be available over DBus first, then
configured to be available over IPMI. This doc should ideally give you some
good step-by-step but you could also take a look at the Witherspoon or
Zaius layers for an example.

Emily

On Mon, Aug 6, 2018, 8:49 PM AKASH G J <akashgj91 at gmail.com> wrote:

> Hi Emily,
>
> I did not configure the temperature sensors to report over dbus interface.
> I am new in this area. Can you provide steps to configure the temperature
> sensors to report over dbus?
>
>
> Thanks and Regards,
>
> Akash
>
> On Mon, Aug 6, 2018 at 9:16 PM, Emily Shaffer <emilyshaffer at google.com>
> wrote:
>
>> Hi Akash,
>>
>> Have you configured your temp sensors to report over dbus already?
>>
>> Emily
>>
>> On Mon, Aug 6, 2018 at 4:58 AM AKASH G J <akashgj91 at gmail.com> wrote:
>>
>>> Hi Team,
>>>
>>> I tried to list sensors and its reading using the command "ipmitool -I
>>> dbus sdr elist full". But temperature sensor and its reading is not
>>> displayed. Please someone help to resolve this problem.
>>>
>>>
>>>
>>> Thanks and Regards,
>>>
>>> Akash
>>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ozlabs.org/pipermail/openbmc/attachments/20180807/88329ba4/attachment.html>