[PATCH linux dev-4.10 v2 0/6] drivers: i2c: FSI-attached I2C master algorithm

[Joel Stanley]

On Thu, May 11, 2017 at 1:22 AM, Eddie James <eajames at linux.vnet.ibm.com> wrote:
> From: "Edward A. James" <eajames at us.ibm.com>
>
> This patch series adds an I2C bus algorithm to drive the I2C master located on
> POWER CPUs. The master is accessed over FSI bus from the service processor.
>
> The driver creates one chardev entry for each port off an I2C master by
> registering one I2C adapter for port. This implementation requires locking of
> the master in the driver to prevent transfers running into each other. The
> master registers are shared between ports.
>
> This patchset also adds the latest in FSI dt bindings from Jeremy Kerr. This
> describes the entire FSI tree structure (master -> slaves -> engines ->
> engine data (such as i2c master ports)). These bindings are required for the
> I2C driver in order to enumerate the ports off each I2C master.
>

I have added this series to dev-4.10. Note that under our kernel
rules, this means you must be in the process of submitting them
upstream :)

I think you can send them to the i2c maintainer with a mention in your
cover letter that it depends on the unmerged FSI series and that you'd
like to kick off the review process for your driver.

Cheers,

Joel


> Edward A. James (6):
>   drivers: i2c: Add FSI-attached I2C master algorithm
>   drivers: i2c: Add port structure to FSI algorithm
>   drivers: i2c: Add transfer implementation for FSI algorithm
>   drivers: i2c: Add I2C master locking to FSI algorithm
>   drivers: i2c: Add bus recovery for FSI algorithm
>   dts: aspeed: witherspoon: Add I2C master under FSI masters
>
>  arch/arm/boot/dts/aspeed-bmc-opp-witherspoon.dts | 156 ++++++
>  drivers/Makefile                                 |   2 +-
>  drivers/i2c/busses/Kconfig                       |  11 +
>  drivers/i2c/busses/Makefile                      |   1 +
>  drivers/i2c/busses/i2c-fsi.c                     | 654 +++++++++++++++++++++++
>  5 files changed, 823 insertions(+), 1 deletion(-)
>  create mode 100644 drivers/i2c/busses/i2c-fsi.c
>
> --
> 1.8.3.1
>