[PATCH linux dev-4.10 v2] leds: pca955x: check for I2C errors
Cédric Le Goater
clg at kaod.org
Mon Aug 28 16:37:05 AEST 2017
This should also allow probing to fail when a pca955x chip is not
found on a I2C bus.
Signed-off-by: Cédric Le Goater <clg at kaod.org>
---
Changes since v1:
- introduced a pca955x_set_value() routine returning an errno
- modified pca955x_gpio_direction_{in,out}put to return an errno
drivers/leds/leds-pca955x.c | 114 ++++++++++++++++++++++++++++++++------------
1 file changed, 83 insertions(+), 31 deletions(-)
diff --git a/drivers/leds/leds-pca955x.c b/drivers/leds/leds-pca955x.c
index 09303fd1fdc6..905729191d3e 100644
--- a/drivers/leds/leds-pca955x.c
+++ b/drivers/leds/leds-pca955x.c
@@ -165,13 +165,18 @@ static inline u8 pca955x_ledsel(u8 oldval, int led_num, int state)
* Write to frequency prescaler register, used to program the
* period of the PWM output. period = (PSCx + 1) / 38
*/
-static void pca955x_write_psc(struct i2c_client *client, int n, u8 val)
+static int pca955x_write_psc(struct i2c_client *client, int n, u8 val)
{
struct pca955x *pca955x = i2c_get_clientdata(client);
+ int ret;
- i2c_smbus_write_byte_data(client,
+ ret = i2c_smbus_write_byte_data(client,
pca95xx_num_input_regs(pca955x->chipdef->bits) + 2*n,
val);
+ if (ret < 0)
+ dev_err(&client->dev, "%s: reg 0x%x, val 0x%x, err %d\n",
+ __func__, n, val, ret);
+ return ret;
}
/*
@@ -181,38 +186,56 @@ static void pca955x_write_psc(struct i2c_client *client, int n, u8 val)
*
* Duty cycle is (256 - PWMx) / 256
*/
-static void pca955x_write_pwm(struct i2c_client *client, int n, u8 val)
+static int pca955x_write_pwm(struct i2c_client *client, int n, u8 val)
{
struct pca955x *pca955x = i2c_get_clientdata(client);
+ int ret;
- i2c_smbus_write_byte_data(client,
+ ret = i2c_smbus_write_byte_data(client,
pca95xx_num_input_regs(pca955x->chipdef->bits) + 1 + 2*n,
val);
+ if (ret < 0)
+ dev_err(&client->dev, "%s: reg 0x%x, val 0x%x, err %d\n",
+ __func__, n, val, ret);
+ return ret;
}
/*
* Write to LED selector register, which determines the source that
* drives the LED output.
*/
-static void pca955x_write_ls(struct i2c_client *client, int n, u8 val)
+static int pca955x_write_ls(struct i2c_client *client, int n, u8 val)
{
struct pca955x *pca955x = i2c_get_clientdata(client);
+ int ret;
- i2c_smbus_write_byte_data(client,
+ ret = i2c_smbus_write_byte_data(client,
pca95xx_num_input_regs(pca955x->chipdef->bits) + 4 + n,
val);
+ if (ret < 0)
+ dev_err(&client->dev, "%s: reg 0x%x, val 0x%x, err %d\n",
+ __func__, n, val, ret);
+ return ret;
}
/*
* Read the LED selector register, which determines the source that
* drives the LED output.
*/
-static u8 pca955x_read_ls(struct i2c_client *client, int n)
+static int pca955x_read_ls(struct i2c_client *client, int n, u8 *val)
{
struct pca955x *pca955x = i2c_get_clientdata(client);
+ int ret;
- return (u8) i2c_smbus_read_byte_data(client,
+ ret = i2c_smbus_read_byte_data(client,
pca95xx_num_input_regs(pca955x->chipdef->bits) + 4 + n);
+ if (ret < 0) {
+ dev_err(&client->dev, "%s: reg 0x%x, err %d\n",
+ __func__, n, ret);
+ return ret;
+ }
+ *val = (u8)ret;
+ return 0;
}
static int pca955x_led_set(struct led_classdev *led_cdev,
@@ -223,6 +246,7 @@ static int pca955x_led_set(struct led_classdev *led_cdev,
u8 ls;
int chip_ls; /* which LSx to use (0-3 potentially) */
int ls_led; /* which set of bits within LSx to use (0-3) */
+ int ret;
pca955x_led = container_of(led_cdev, struct pca955x_led, led_cdev);
pca955x = pca955x_led->pca955x;
@@ -232,7 +256,9 @@ static int pca955x_led_set(struct led_classdev *led_cdev,
mutex_lock(&pca955x->lock);
- ls = pca955x_read_ls(pca955x->client, chip_ls);
+ ret = pca955x_read_ls(pca955x->client, chip_ls, &ls);
+ if (ret)
+ goto out;
switch (value) {
case LED_FULL:
@@ -252,26 +278,37 @@ static int pca955x_led_set(struct led_classdev *led_cdev,
* OFF, HALF, or FULL. But, this is probably better than
* just turning off for all other values.
*/
- pca955x_write_pwm(pca955x->client, 1,
- 255 - value);
+ ret = pca955x_write_pwm(pca955x->client, 1, 255 - value);
+ if (ret)
+ goto out;
ls = pca955x_ledsel(ls, ls_led, PCA955X_LS_BLINK1);
break;
}
- pca955x_write_ls(pca955x->client, chip_ls, ls);
+ ret = pca955x_write_ls(pca955x->client, chip_ls, ls);
+out:
mutex_unlock(&pca955x->lock);
- return 0;
+ return ret;
}
#ifdef CONFIG_LEDS_PCA955X_GPIO
/*
* Read the INPUT register, which contains the state of LEDs.
*/
-static u8 pca955x_read_input(struct i2c_client *client, int n)
+static int pca955x_read_input(struct i2c_client *client, int n, u8 *val)
{
- return (u8)i2c_smbus_read_byte_data(client, n);
+ int ret = i2c_smbus_read_byte_data(client, n);
+
+ if (ret < 0) {
+ dev_err(&client->dev, "%s: reg 0x%x, err %d\n",
+ __func__, n, ret);
+ return ret;
+ }
+ *val = (u8)ret;
+ return 0;
+
}
static int pca955x_gpio_request_pin(struct gpio_chip *gc, unsigned int offset)
@@ -285,23 +322,32 @@ static int pca955x_gpio_request_pin(struct gpio_chip *gc, unsigned int offset)
return -EBUSY;
}
-static void pca955x_gpio_set_value(struct gpio_chip *gc, unsigned int offset,
- int val)
+static int pca955x_set_value(struct gpio_chip *gc, unsigned int offset,
+ int val)
{
struct pca955x *pca955x = gpiochip_get_data(gc);
struct pca955x_led *led = &pca955x->leds[offset];
if (val)
- pca955x_led_set(&led->led_cdev, LED_FULL);
+ return pca955x_led_set(&led->led_cdev, LED_FULL);
else
- pca955x_led_set(&led->led_cdev, LED_OFF);
+ return pca955x_led_set(&led->led_cdev, LED_OFF);
+}
+
+static void pca955x_gpio_set_value(struct gpio_chip *gc, unsigned int offset,
+ int val)
+{
+ pca955x_set_value(gc, offset, val);
}
static int pca955x_gpio_get_value(struct gpio_chip *gc, unsigned int offset)
{
struct pca955x *pca955x = gpiochip_get_data(gc);
struct pca955x_led *led = &pca955x->leds[offset];
- u8 reg = pca955x_read_input(pca955x->client, led->led_num / 8);
+ u8 reg = 0;
+
+ /* There is nothing we can do about errors */
+ pca955x_read_input(pca955x->client, led->led_num / 8, ®);
return !!(reg & (1 << (led->led_num % 8)));
}
@@ -310,17 +356,13 @@ static int pca955x_gpio_direction_input(struct gpio_chip *gc,
unsigned int offset)
{
/* To use as input ensure pin is not driven */
- pca955x_gpio_set_value(gc, offset, 0);
-
- return 0;
+ return pca955x_set_value(gc, offset, 0);
}
static int pca955x_gpio_direction_output(struct gpio_chip *gc,
unsigned int offset, int val)
{
- pca955x_gpio_set_value(gc, offset, val);
-
- return 0;
+ return pca955x_set_value(gc, offset, val);
}
#endif /* CONFIG_LEDS_PCA955X_GPIO */
@@ -495,19 +537,29 @@ static int pca955x_probe(struct i2c_client *client,
return err;
/* Turn off LED */
- pca955x_led_set(&pca955x_led->led_cdev, LED_OFF);
+ err = pca955x_led_set(&pca955x_led->led_cdev, LED_OFF);
+ if (err)
+ return err;
}
}
/* PWM0 is used for half brightness or 50% duty cycle */
- pca955x_write_pwm(client, 0, 255-LED_HALF);
+ err = pca955x_write_pwm(client, 0, 255 - LED_HALF);
+ if (err)
+ return err;
/* PWM1 is used for variable brightness, default to OFF */
- pca955x_write_pwm(client, 1, 0);
+ err = pca955x_write_pwm(client, 1, 0);
+ if (err)
+ return err;
/* Set to fast frequency so we do not see flashing */
- pca955x_write_psc(client, 0, 0);
- pca955x_write_psc(client, 1, 0);
+ err = pca955x_write_psc(client, 0, 0);
+ if (err)
+ return err;
+ err = pca955x_write_psc(client, 1, 0);
+ if (err)
+ return err;
#ifdef CONFIG_LEDS_PCA955X_GPIO
if (ngpios) {
--
2.13.5
More information about the openbmc
mailing list