[PATCH 6/7]: Revised [PATCH 31/42]: ethernet: add PCI error recovery to ixgb dev driver

[linas]

On Mon, Nov 07, 2005 at 01:57:27PM -0600, linas was heard to remark:
> On Mon, Nov 07, 2005 at 10:27:27AM -0800, Greg KH was heard to remark:
> > 3) realy strong typing that sparse can detect.

Replace-Subject: PCI Error Recovery: ixgb network device driver

Various PCI bus errors can be signaled by newer PCI controllers.  This
patch adds the PCI error recovery callbacks to the intel ten-gigabit
ethernet ixgb device driver. The patch has been tested, and appears
to work well.

Signed-off-by: Linas Vepstas <linas at linas.org>

--
Index: linux-2.6.14-mm1/drivers/net/ixgb/ixgb_main.c
===================================================================
--- linux-2.6.14-mm1.orig/drivers/net/ixgb/ixgb_main.c	2005-11-07 13:55:25.431278896 -0600
+++ linux-2.6.14-mm1/drivers/net/ixgb/ixgb_main.c	2005-11-07 15:02:14.779406268 -0600
@@ -132,6 +132,16 @@
 static void ixgb_netpoll(struct net_device *dev);
 #endif
 
+static pers_result_t ixgb_io_error_detected (struct pci_dev *pdev, pci_channel_state_t state);
+static pers_result_t ixgb_io_slot_reset (struct pci_dev *pdev);
+static void ixgb_io_resume (struct pci_dev *pdev);
+
+static struct pci_error_handlers ixgb_err_handler = {
+	.error_detected = ixgb_io_error_detected,
+	.slot_reset = ixgb_io_slot_reset,
+	.resume = ixgb_io_resume,
+};
+
 /* Exported from other modules */
 
 extern void ixgb_check_options(struct ixgb_adapter *adapter);
@@ -141,6 +151,8 @@
 	.id_table = ixgb_pci_tbl,
 	.probe    = ixgb_probe,
 	.remove   = __devexit_p(ixgb_remove),
+	.err_handler = &ixgb_err_handler,
+
 };
 
 MODULE_AUTHOR("Intel Corporation, <linux.nics at intel.com>");
@@ -1654,8 +1666,16 @@
 	unsigned int i;
 #endif
 
+#ifdef XXX_CONFIG_IXGB_EEH_RECOVERY
+	if(unlikely(icr==EEH_IO_ERROR_VALUE(4))) {
+		if (eeh_slot_is_isolated (adapter->pdev))
+		// disable_irq_nosync (adapter->pdev->irq);
+		return IRQ_NONE;      /* Not our interrupt */
+	}
+#else
 	if(unlikely(!icr))
 		return IRQ_NONE;  /* Not our interrupt */
+#endif /* CONFIG_IXGB_EEH_RECOVERY */
 
 	if(unlikely(icr & (IXGB_INT_RXSEQ | IXGB_INT_LSC))) {
 		mod_timer(&adapter->watchdog_timer, jiffies);
@@ -2125,4 +2145,70 @@
 }
 #endif
 
+/* -------------- PCI Error Recovery infrastructure ---------------- */
+/** ixgb_io_error_detected() is called when PCI error is detected */
+static pers_result_t ixgb_io_error_detected (struct pci_dev *pdev, pci_channel_state_t state)
+{
+	struct net_device *netdev = pci_get_drvdata(pdev);
+	struct ixgb_adapter *adapter = netdev->priv;
+
+	if(netif_running(netdev))
+		ixgb_down(adapter, TRUE);
+
+	/* Request a slot reset. */
+	return PERS_RESULT_NEED_RESET;
+}
+
+/** ixgb_io_slot_reset is called after the pci bus has been reset.
+ *  Restart the card from scratch.
+ *  Implementation resembles the first-half of the
+ *  ixgb_resume routine.
+ */
+static pers_result_t ixgb_io_slot_reset (struct pci_dev *pdev)
+{
+	struct net_device *netdev = pci_get_drvdata(pdev);
+	struct ixgb_adapter *adapter = netdev->priv;
+
+	if(pci_enable_device(pdev)) {
+		printk(KERN_ERR "ixgb: Cannot re-enable PCI device after reset.\n");
+		return PERS_RESULT_DISCONNECT;
+	}
+	pci_set_master(pdev);
+
+	/* Perform card reset only on one instance of the card */
+	if (0 != PCI_FUNC (pdev->devfn))
+		return PERS_RESULT_RECOVERED;
+
+	ixgb_reset(adapter);
+
+	return PERS_RESULT_RECOVERED;
+}
+
+/** ixgb_io_resume is called when the error recovery driver
+ *  tells us that its OK to resume normal operation.
+ *  Implementation resembles the second-half of the
+ *  ixgb_resume routine.
+ */
+static void ixgb_io_resume (struct pci_dev *pdev)
+{
+	struct net_device *netdev = pci_get_drvdata(pdev);
+	struct ixgb_adapter *adapter = netdev->priv;
+
+	if(netif_running(netdev)) {
+		if(ixgb_up(adapter)) {
+			printk ("ixgb: can't bring device back up after reset\n");
+			return;
+		}
+	}
+
+	netif_device_attach(netdev);
+	if(netif_running(netdev))
+		mod_timer(&adapter->watchdog_timer, jiffies);
+
+	/* Reading all-ff's from the adapter will completely hose
+	 * the counts and statistics. So just clear them out */
+	memset(&adapter->stats, 0, sizeof(struct ixgb_hw_stats));
+	ixgb_update_stats(adapter);
+}
+
 /* ixgb_main.c */