Uboot-1.2.0 on MPC8360EMDS board

[mike zheng]

Hello,

I am having problem when I try to bootup MPC8360EMDS with Uboot1.2.
The following are logs. The board reboot when the uboot tried to run
on the RAM. Any idea on this issue?

Thanks,

Mike


U-Boot 1.2.1 (Sep 23 2008 - 14:35:42) MPC83XX

Clock configuration:
  Coherent System Bus:  264 MHz
  Core:                 528 MHz
  QE:                   396 MHz
  Local Bus Controller: 264 MHz
  Local Bus:             66 MHz
  DDR:                  264 MHz
  DDR Secondary:        264 MHz
  SEC:                   88 MHz
  I2C1:                 264 MHz
  I2C2:                 264 MHz
CPU: MPC8360E, Rev: 21 at 528 MHz
Board: Freescale MPC8360EMDS
I2C:   ready
DRAM:
cs0_bnds = 0x0000000f
cs0_config = 0x80000102
DDR:bar=0x00000000
DDR:ar=0x8000001b
DDR:Module maximum data rate is: 400Mhz
DDR:Effective data rate is: 266Mhz
DDR:The MSB 1 of CAS Latency is: 4
Errata DDR6 (debug_reg=0x002c0000)
DDR:timing_cfg_1=0x37353321
DDR:timing_cfg_2=0x00000800

   DDR DIMM: data bus width is 64 bit with ECC
DDR:sdram_mode=0x00000032
DDR:sdram_interval=0x045b0100
DDR:sdram_clk_cntl=0x00000000
   DDRC ECC mode: OFF
DDR:sdram_cfg=0xc2000000

   SDRAM on Local Bus: 64 MB
   DDR RAM: 256 MB
Top of RAM usable for U-Boot at: 10000000
Reserving 205k for U-Boot at: 0ffcc000
Reserving 136k for malloc() at: 0ffaa000
Reserving 76 Bytes for Board Info at: 0ffa9fb4
Reserving 104 Bytes for Global Data at: 0ffa9f4c
Stack Pointer at: 0ffa9f28