EDK10.1 and emaclite

[Georg Schardt]

Hi again,

mmh, there is no kernel message with PHY detection, but all PHY drivers 
are compiled in.
i looked at my xps project and there is only one ip-core "Ethernet_MAC" 
with type "xps_ethernetlite".
is it possible that the phy connection is missing ? i use the base 
system builder with the board support files supported from avnet.

where can i look for the ethernet speed ? the ethernetlite ip has no 
speed options

thanks for your help
georg

Neeraj Garg wrote:
> Hi Georg,
>
> Can you post linux bootup message where its says PHY is detected at 
> paticular address, and check with your hardware what is actual address 
> of PHY. Also I would like to know the configuration of your hardware 
> whether its configured of 10MBPS OR 100MBPS.
>
>
> ------------------------------------------------------------------------------------------ 
>
> -- 
> Neeraj Garg
>
>
>
> Message: 3
> Date: Mon, 08 Sep 2008 18:29:53 +0200
> From: Georg Schardt <schardt at team-ctech.de>
> Subject: EDK10.1 and emaclite
> To: linuxppc-embedded at ozlabs.org
> Message-ID: <48C55301.4070208 at team-ctech.de>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
>
> Hi all,
>
> im trying to use the emaclite core which comes with the EDK10.1 with 
> the 2.6.26 kernel from git.xilinx.com on virtex4fx12 minimodul. the 
> emac is detect by the kernel:
>
> xilinx_emaclite xilinx_emaclite.0: MAC address is now  2: 0: 0: 0: 0: 0
> xilinx_emaclite xilinx_emaclite.0: using fifo mode.
> xilinx_emaclite xilinx_emaclite.0: Xilinx EMACLite at 0x81000000 
> mapped to 0xC5060000, irq=0
>
> i can change the mac-address with ifconfig and i can give an 
> ip-address to the device,
> but a ping is not possible and arp is not working. i think that the 
> phy is not working right.
>
> has someone others the same problem ? what can i changed ? i have 
> tried out all possible phy driver in the linux  kernel
>
> a setup with the lltemac is working fine, but i want to use the emaclite
>
> thanks
> regards
> georg
>