MTD map drivers (FSL UPM NAND)

[Alemao]

Hi all,

Im trying to use a physmap driver for NOR and NAND flash devices.

With NOR, everything ok. It uses CFI driver.

The problem is with NAND, cause it is connected at Freescale
LocalBus UPM, and at a first look, the UPM driver is loading after the
physmap (lines 14-15 in kernel output)

Here some outputs from the board:

Bootloader (U-Boot 1.2.0):

CPU:   e300c1, MPC8360E, Rev: 21 at 499.999 MHz, CSB:  333 MHz
Board: MPC8360KTX
I2C:   ready
DDR RAM: 128 MB
FLASH: 16 MB
NAND:  64 MiB
In:    serial
Out:   serial
Err:   serial


Kernel (linux-2.6.17):

1               physmap nor flash device: 1000000 at ff000000
2               NOR flash: Found 1 x16 devices at 0x0 in 16-bit bank
3                Amd/Fujitsu Extended Query Table at 0x0040
4                number of CFI chips: 1
5               Using physmap partition definition
6               Creating 6 MTD partitions on "NOR flash":
7               0x00000000-0x00040000 : "u-boot"
8               0x00040000-0x00060000 : "env."
9               0x00060000-0x00080000 : "sys"
10              0x00080000-0x000c0000 : "logs"
11              0x000c0000-0x00860000 : "admin"
12              0x00860000-0x01000000 : "users"
13
14              physmap nand flash device: 4000000 at 60000000
15              UPM: User-Programmable Machine NAND driver


Device Tree Source:

localbus at e0005000 {
  compatible = "fsl,board-localbus";
  #address-cells = <2>;
  #size-cells = <1>;
  reg = <e0005000 d8>;    // BRx, ORx, etc

  ranges = <0 0 ff000000 1000000     // nor flash,  16 MB
                    1 0 60000000 4000000>;   // nand flash, 64 MB

  flash at 0,0 {
      compatible = "atmel,29LV256", "cfi-flash";
      reg = <0 0 1000000>;
      bank-width = <2>;
      device-width = <1>;
  };

  nand at 1,0 {
      compatible = "stmicro,NAND512W3A", "fsl,upm-nand";
      reg = <1 0 4000000>;   //reg = <1 0 1>;
      width = <1>;
      upm = "A";
      upm-addr-offset = <16>;
      upm-cmd-offset = <8>;
      gpios = <4 18>;
      gpio-parent = <&qe_pio>;
      wait-pattern;
      wait-write;
  };
};

The CFI driver is at linux/drivers/mtd/chips
The UPM driver is at linux/drivers/mtd/nand

So, how can I load the UPM driver before physmap?

Thanks in advance,

--
Alemao