BDI2000 configuration file for MPC8313E-RDB

[Frank Prepelica]

> > Leonid asked:
> > And here most important question comes: for our actual HW we are
going 
> > to use ST-Micro NAND flash, one of NAND512-B, NAND01G-B, NAND02G-B, 
> > NAND04G-B and NAND08G-B. Is BDI2000 capable of programming these 
> > flashes? What changes in .cfg file are required?

> Sorry, but the BDI does not support programming any NAND flash.
> You can write your own driver. Then load the data and the driver into 
> SDRAM via the BDI and execute it.

Well, I think I have to try this, if there's really no other way. 
I'm not quite sure, maybe you know the PowerTAB Pro JTAG Debugger,
(it's recommended in the manuals) could this one get directly access
to NAND memory?

> I'm afraid I didn't understand you. Are you saying that you actually
> were able to program NAND using BDI2000? I would like to know how you
> achieved that. I suspect that was some kind of "indirect" procedure,
> Ruedi wrote about, but please provide details.

Uhm, it's possible that achieved that in an "indirect" way that I was
not aware of. But as I said, the complete flash and ram was empty, just
loaded 
the corresponding BDI config file to BDI2000 JTAG and I got access to
flash memory where I placed the bootloader image. Hmm, anyway ;)

The BDI config: http://www.ultsol.com/config/Emb%20Planet/83xx.cfg


Best regards

Frank