MPC5200b kernel module memory mapping

[Steven Kaiser]

Markus:

> > sure I am setting up the LocalBus chip select registers ok.
> 
> I would guess this is not the case. What kind of device is this?

It is a Freescale MPC5200b:
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=MPC5200B

You are correct.  I was so concerned about the linux driver stuff (
request_region(), ioremap(), etc ), that I was locked into endless studies
on that and see now I clearly overlooked some simple chip setting up.  Doh!
Thanks for reorienting my focus--

int init_module(void) { ...

	// reserve a page of memory for our hardware /proc/iomem
	if ( check_region(MALab_MM_START,MALab_MM_SIZE) ) {
		printk (KERN_ALERT "LED init_module: memory already in
use\n");
		return -EBUSY;
	}
	request_region(MALab_MM_START,MALab_MM_SIZE,LED_DEVICE_NAME);

	// enable LocalBus chip select CS2 to hit on our address range
	*(volatile u32 *)MPC5xxx_MM_IPBI &= ~0x00040000;
	*(volatile u16 *)(MPC5xxx_MM_CS2_START + 2) = MALab_MM_START >> 16;
	*(volatile u16 *)(MPC5xxx_MM_CS2_STOP + 2) = MALab_MM_END >> 16;
	*(volatile u32 *)MPC5xxx_MM_IPBI |= 0x00040000;

	// LocalBus Chip Select 2,3 Configuration Register
	*(volatile u32 *)(MPC5xxx_MBAR + 0x0308) = 0x03031110;
	*(volatile u32 *)(MPC5xxx_MBAR + 0x030c) = 0x03031110;
	// LocalBus Chip Select Control Register
	*(volatile u32 *)(MPC5xxx_MBAR + 0x0318) |= 0x01000000;

	// map our physical address into kernal virtual address space
	ioaddr = ioremap(MALab_MM_START,MALab_MM_SIZE);
	printk(KERN_ALERT "ioaddr: 0x%08x\n", (u32)ioaddr);


and later, any of these calls work: