11-16-05 2.6.14 on AMCC Yosemite boar d(PCI-IDE card boot error)

Wed Sep 13 13:44:36 EST 2006

Hi Mr. KylongMu & all,

Have you solved the issues about PCI-IDE card?

  I also have tested two PCI-IDE cards and a PCI-SATA card with
2.6.13(packaged in AMCC CD) and 2.6.14(ELDK ) kernel on Yosemite board,
this issues are the same with Mr. KylongMu. the PCI-SATA is work fine.
but the two PCI-IDE  cards, ITE8212 and PDC20269 failed, the panic
message was  similar with Mr. KylongMu. the attached file is the
ITE8212 module driver OOPS log.

would you please give me some advice about it?

Thanks and Best regards,

stephen

KylongMu wrote:

> Dear Denk,

>

> Thanks for your help; it makes my Yosemite run up! I'm try to add a 

> PCI-IDE

>

> Card on it. I test my Promise-PDC20268 card and AEC6280 (ATP865-B chip 

> type) card,

>

> Both of them all failed with same error, the boot message included in 

> the attachment.

>

> The kernel configure is based on the Yosemite_defconfig, add with:

>

> Device Drivers-->

>

> ATA/ATAPI/MFM/RLL support-->

>

> [*]AEC62XX Chipset support

>

> [*]PROMISE PDC202{68|69|70|71|75|76|77} SUPPORT

>

> Both of the PCI-IDE cards can work with X86PC+FEDORA4 configure, I 

> don¡¯t know

>

> What cause them fail on Yosemite with final 2.6.14 kernel.

>

> About my 2.6.14 tree, I type with ¡°cg-log ¨Cs¡± command it shows:

>

> 99a21389c2b0e55f30b6cf6550cb492b87dbaa3b Heiko Schocher 2005-11-11 

> 12:47 [PATCH] ppc32: fix Kernel Panic for PM82x Board with gcc-4.0.

>

> ff1df84b3c3154ffdb646941e1c70d17554e3042 Wolfgang Denk 2005-11-10 

> 00:41 Merge with /home/wd/git/linux-2.6/stefan_roese

>

> It only shows 2.6.14 on the kernel message, I don¡¯t know why it 

> doesn¡¯t show the message as you told.

>

> But it can work, and fixed the bugs on Yosemite.

>

> Cordially,

>

> Kylong Mu

>

>------------------------------------------------------------------------

>

>U-Boot 1.1.4 (Nov 11 2005 - 19:35:30)

>

>AMCC PowerPC 440EP Rev. B

>Board: Yosemite - AMCC PPC440EP Evaluation Board

>        VCO: 1066 MHz

>        CPU: 533 MHz

>        PLB: 133 MHz

>        OPB: 66 MHz

>        EPB: 66 MHz

>        PCI: 66 MHz

>I2C:   ready

>DRAM:  256 MB

>FLASH: 64 MB

>PCI:   Bus Dev VenId DevId Class Int

>        00  0c  1191  0009  0180  00

>In:    serial

>Out:   serial

>Err:   serial

>Net:   ppc_4xx_eth0, ppc_4xx_eth1

>

>Type "run flash_nfs" to mount root filesystem over NFS

>

>Hit any key to stop autoboot:  0

>=> tftp 400000 uImage

>ENET Speed is 100 Mbps - FULL duplex connection

>Using ppc_4xx_eth0 device

>TFTP from server 192.168.0.93; our IP address is 192.168.0.66

>Filename 'uImage'.

>Load address: 0x400000

>Loading: #################################################################

>         #################################################################

>         #################################################################

>         ###########################################

>done

>Bytes transferred = 1217393 (129371 hex)

>=> bootram

>Unknown command 'bootram' - try 'help'

>=> run bootram

>## Booting image at 00400000 ...

>   Image Name:   Linux-2.6.14

>   Image Type:   PowerPC Linux Kernel Image (gzip compressed)

>   Data Size:    1217329 Bytes =  1.2 MB

>   Load Address: 00000000

>   Entry Point:  00000000

>   Verifying Checksum ... OK

>   Uncompressing Kernel Image ... OK

>## Loading RAMDisk Image at fed40000 ...

>   Image Name:   Yosemite Ramdisk

>   Image Type:   PowerPC Linux RAMDisk Image (gzip compressed)

>   Data Size:    17770706 Bytes = 16.9 MB

>   Load Address: 00000000

>   Entry Point:  00000000

>   Verifying Checksum ... OK

>   Loading Ramdisk to 0ee47000, end 0ff398d2 ... OK

>Linux version 2.6.14 (root at dxp) (gcc version 4.0.0) #7 Sun Nov 13 21:59:01 CST 2005

>AMCC PowerPC 440EP Yosemite Platform

>Built 1 zonelists

>Kernel command line: ramdisk_size=49152 root=/dev/ram rw
ip=192.168.0.66:192.168.0.93::255.255.255.0:yosemite:eth0:off panic=1
console=ttyS0,115200

>PID hash table entries: 2048 (order: 11, 32768 bytes)

>Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)

>Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)

>Memory: 239616k available (1860k kernel code, 596k data, 140k init, 0k highmem)

>Mount-cache hash table entries: 512

>checking if image is initramfs...it isn't (no cpio magic); looks like an initrd

>softlockup thread 0 started up.

>Freeing initrd memory: 17354k freed

>NET: Registered protocol family 16

>PCI: Probing PCI hardware

>usbcore: registered new driver usbfs

>usbcore: registered new driver hub

>SCSI subsystem initialized

>io scheduler noop registered

>io scheduler anticipatory registered

>io scheduler deadline registered

>io scheduler cfq registered

>usbmon: debugfs is not available

>ppc-soc-ohci ppc-soc-ohci.0: USB Host Controller

>ppc-soc-ohci ppc-soc-ohci.0: new USB bus registered, assigned bus number 1

>ppc-soc-ohci ppc-soc-ohci.0: irq 40, io mem 0xef601000

>usb usb1: Product: USB Host Controller

>usb usb1: Manufacturer: Linux 2.6.14 ohci_hcd

>usb usb1: SerialNumber: PPC-SOC USB

>hub 1-0:1.0: USB hub found

>hub 1-0:1.0: 2 ports detected

>Initializing USB Mass Storage driver...

>usbcore: registered new driver usb-storage

>USB Mass Storage support registered.

>pegasus: v0.6.12 (2005/01/13), Pegasus/Pegasus II USB Ethernet driver

>usbcore: registered new driver pegasus

>Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled

>serial8250: ttyS0 at MMIO 0x0 (irq = 0) is a 16550A

>serial8250: ttyS1 at MMIO 0x0 (irq = 1) is a 16550A

>RAMDISK driver initialized: 16 RAM disks of 49152K size 1024 blocksize

>PPC 4xx OCP EMAC driver, version 3.53

>mal0: initialized, 4 TX channels, 2 RX channels

>zmii0: bridge in RMII mode

>eth0: emac0, MAC 00:10:ec:00:87:40

>eth0: found Generic MII PHY (0x01)

>eth1: emac1, MAC 00:10:ec:00:87:47

>eth1: found Generic MII PHY (0x03)

>Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2

>ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx

>Data machine check in kernel mode.

>PLB0: BEAR=0x0000000000000000 ACR=  0x00000000 BESR= 0xfffff7ff

>POB0: BEAR=0xc27e3194ffffffff BESR0=0x00000000 BESR1=0x00000000

>OPB0: BEAR=0x0000000000000151 BSTAT=0x00000000

>Oops: machine check, sig: 7 [#1]

>NIP: 00000000 LR: C0263628 SP: CFF41F40 REGS: c0271f50 TRAP: 0202    Not tainted

>MSR: 00000000 EE: 0 PR: 0 FP: 0 ME: 0 IR/DR: 00

>TASK = c04f8b10[1] 'swapper' THREAD: cff40000

>Last syscall: 120

>GPR00: FDFFEF02 CFF41F40 C04F8B10 C04FC000 C026C6B4 C04FC000 00000009 CFF41EF4

>GPR08: C04F9F70 00000000 00004000 C0270000 24254322 61000408 0FFB6800 00000001

>GPR16: 00800000 0FFCEAD4 FFFFFFFF 00000000 007FFF00 0FFB1210 00000003 00000002

>GPR24: C01D0000 C01D0000 C0270000 C01D0000 C0270000 C0223E10 C026C6B4 C04FC000

>NIP [00000000] 0x0

>LR [c0263628] aec62xx_init_one+0x38/0x48

>Call trace:

> [c0263628] aec62xx_init_one+0x38/0x48

> [c02649b8] ide_scan_pcidev+0x68/0xb0

> [c0264a34] ide_scan_pcibus+0x34/0xe8

> [c026492c] ide_init+0x68/0x8c

> [c00013ac] init+0xb4/0x254

> [c00046c0] kernel_thread+0x48/0x64

>Data machine check in kernel mode.

>PLB0: BEAR=0x0000000000000000 ACR=  0x00000000 BESR= 0xfffff7ff

>POB0: BEAR=0xc27e3194ffffffff BESR0=0x00000000 BESR1=0x00000000

>OPB0: BEAR=0x0000000000000151 BSTAT=0x00000000

>Oops: machine check, sig: 7 [#2]

>NIP: 00000000 LR: C000235C SP: C0271E70 REGS: c0271f50 TRAP: 0202    Not tainted

>MSR: 00000000 EE: 0 PR: 0 FP: 0 ME: 0 IR/DR: 00

>TASK = c04f8b10[1] 'swapper' THREAD: cff40000

>Last syscall: 120

>GPR00: 08000000 C0271E70 C04F8B10 C0271E80 00001568 FFFFFFFF C0270000 00004000

>GPR08: C0270000 C000235C 00021002 C00039E8 C04F8CD8 61000408 0FFB6800 00000001

>GPR16: 00800000 0FFCEAD4 FFFFFFFF 00000000 007FFF00 0FFB1210 00000003 00000002

>GPR24: C01D0000 C01D0000 C0270000 C01D0000 C0270000 C0223E10 00000007 C0271F50

>NIP [00000000] 0x0

>LR [c000235c] ret_from_except+0x0/0x18

>Kernel panic - not syncing: Attempted to kill init!

> <0>Rebooting in 1 seconds..

>

>  

>

>------------------------------------------------------------------------

>

>_______________________________________________

>Linuxppc-embedded mailing list

>Linuxppc-embedded at ozlabs.org

>https://ozlabs.org/mailman/listinfo/linuxppc-embedded

>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20060913/06782d66/attachment.htm 
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: pci-ide-card-oops.txt
Url: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20060913/06782d66/attachment.txt 