PQ2FADS_ZU: u-boot-1.1.4, eldk.3.1.1, linux-2.4.25 boots problem

[KokHow Teh]

Hi;
      I use the above software, apply linuxppc-2005-03-06-2006-02-15.patch
from http://mpc8260sar.sourceforge.net/, `make PQ2FADS_config`, not using
devfs and never manage to boot the kernel:

u-boot>  printenv
ramboot=setenv bootargs root=/dev/ram rw;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile
;bootm $loadaddr $ramdiskaddr
bootdelay=10
baudrate=115200
ethaddr=08:00:3E:33:44:56
ipaddr=147.128.28.44
serverip=147.128.28.42
rootpath="/fadsroot"
gatewayip=147.128.28.1
netmask=255.255.254.0
hostname=PQ2FADS-ZU
bootfile="uImage.linux"
netdev=eth0
ramdiskaddr=400000
ramdiskfile=uInitRD
ethact=FCC2 ETHERNET
testdramdata=y
testdramaddress=y
testdramwalk=n
x86_run_bios=on
bootcmd=run nfsboot
nfsargs=setenv bootargs $bootargs root=/dev/nfs rw nfsroot=$serverip:$rootpath
setconsole=setenv bootargs $console
addip=setenv bootargs $bootargs ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:$netdev:off
loadaddr=0x1000000
nfsboot=tftp $loadaddr $bootfile; run setconsole nfsargs addip; echo $bootargs; bootm
console=console=ttyS0,115200n8 console=tty0
stdin=serial
stdout=serial
stderr=serial

Environment size: 891/262140 bytes
u-boot>
u-boot> boot
Using FCC2 ETHERNET device
TFTP from server 147.128.28.42; our IP address is 147.128.28.44
Filename 'uImage.linux'.
Load address: 0x1000000
Loading: #################################################################
         #################################################################
         ######################################################
done
Bytes transferred = 941606 (e5e26 hex)
console=ttyS0,115200n8 console=tty0 root=/dev/nfs rw nfsroot=147.128.28.42:/fadsroot ip=147.128.
28.44:147.128.28.42:147.128.28.1:255.255.254.0:PQ2FADS-ZU:eth0:off
## Booting image at 01000000 ...
   Image Name:   Linux Kernel Image
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    941542 Bytes = 919.5 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK


U-Boot 1.1.4 (Feb 15 2006 - 16:19:49)

MPC8260 Reset Status: Check Stop, External Soft, External Hard


      I have tried console=ttyCPM0,115200n8 console=tty0 and it makes no difference. BTW, which one should be used for serial console in 2.4.x kernel
for this PowerQUICC II 8280 platform? ttySx or ttyCPMx?
      Any insight is appreciated.

Regards,
TEH