Gianfar eth driver on 8540 ppc - for 2.4 and 2.6 : different outputs

Matthew McClintock msm at
Sat Aug 12 00:30:32 EST 2006

On Fri, 2006-08-11 at 18:13 +0530, Prashant Yendigeri wrote:
> Hi, 
> This is a standard board designed by GDA technologies Inc.
> ( and eth on 2.4.20 works very much. 

I used a 8540 GDA board once upon a time and all I needed to do was to
change the PHY address. Lookat your 2.4 source and determine what the
correct value is and double check.


More information about the Linuxppc-embedded mailing list