mpc8560ads PCI bus

[Greg Weeks]

Switch bank SW1 switch #4 was on which stops config accesses from making 
it on the bus. It works fine now.

Greg Weeks

Clemens Koller wrote:

> Hello, Greg,
>
> I am working on an mpc8540_ads-like board and recently, I ran into data
> corruption problems with a Silicon Motion SM501 (Rev AA) PCI graphics 
> card. From my current point of view it seems that Kernel 2.6.11 PCI 
> works well. I am about to check the hardware and signal integrity.
>
> BTW: I am working with a Promise Ultra-TX133 IDE controller (PDC20269)
> which is fine with 66MHz PCICLK.
>
> Greets,
>
> Clemens
>
>
>> Has anyone else tried to get the PCI bus working on the mpc8560ads 
>> board at 2.6.11? The card enumerates, but the I/O resource regions 
>> aren't getting set up.
>>
>> -bash-2.05b# lspci -vv
>> 00:03.0 Unknown mass storage controller: Silicon Image, Inc. 
>> (formerly CMD Technology Inc) PCI0680 Ultra ATA-133 Host Controller 
>> (rev 02)
>>        Subsystem: Silicon Image, Inc. (formerly CMD Technology Inc) 
>> PCI0680 Ultra ATA-133 Host Controller
>>        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- 
>> ParErr- Stepping- SERR- FastB2B-
>>        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium 
>> >TAbort- <TAbort- <MAbort- >SERR- <PERR+
>>        Interrupt: pin A routed to IRQ 100
>>        Region 0: I/O ports at <unassigned> [disabled]
>>        Region 1: I/O ports at <unassigned> [disabled]
>>        Region 2: I/O ports at <unassigned> [disabled]
>>        Region 3: I/O ports at <unassigned> [disabled]
>>        Region 4: I/O ports at <unassigned> [disabled]
>>        Capabilities: [60] Power Management version 2
>>                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA 
>> PME(D0-,D1-,D2-,D3hot-,D3cold-)
>>                Status: D0 PME-Enable- DSel=0 DScale=2 PME-
>>
>> Greg Weeks
>> _______________________________________________
>> Linuxppc-embedded mailing list
>> Linuxppc-embedded at ozlabs.org
>> https://ozlabs.org/mailman/listinfo/linuxppc-embedded
>>
>