Impact of change n port size

[Atit_Shah]

Hi All,

	I have a kernel image which works perfectly for my reference
board. When I try to port the same image on my board I seem to be facing
problems. The only difference I see between the reference board and my
board is the port size and capacity of RAM. 
	I have taken care of sending the right value for the RAM size
through BD_INFO. Would there be and where all would the change be, if
any, in the kernel code OR when I make the kernel image ie through "make
menuconfig" / "menu xconfig" required to be made for port size of RAM?
	Out of curiosity what would be the change required for different
FLASH port size again on the kernel side.
	
Thanks and Regards
Atit


DISCLAIMER:
This email (including any attachments) is intended for the sole use of the intended recipient/s and may contain material that is CONFIDENTIAL AND PRIVATE COMPANY INFORMATION. Any review or reliance by others or copying or distribution or forwarding of any or all of the contents in this message is STRICTLY PROHIBITED. If you are not the intended recipient, please contact the sender by email and delete all copies; your cooperation in this regard is appreciated.