RPX-CLLF porting

[Prabhakar Kalasani]

Thank you  sam
I made Binary Image and I could boot my target.

Rgards,
KP

-----Original Message-----
From: owner-linuxppc-embedded at lists.linuxppc.org
[mailto:owner-linuxppc-embedded at lists.linuxppc.org]On Behalf Of Song Sam
Sent: Saturday, May 15, 2004 12:03 AM
To: Prabhakar Kalasani; linuxppc-embedded at lists.linuxppc.org
Subject: Re: RPX-CLLF porting



Prabhakar Kalasani <kalasani at sena.com> wrote:
> I have got RPX-CLLF target , I'm trying to port PPC Linux , I made
> tftp,nfs and DHCP setup and I could able to load the kernel using tftp
> , the problem is I couldn't able to run the kernel .

> File                                           =
> vmlinux
> ENET                                           =
> 0010EC002D1E
> DefaultENET                                    =
> ENET
> TftpRAM                                        =
> High
> Start                                          =
> 400000
> Format                                         =
> NetBin

> Enter server filename   <vmlinux> :
> Enter (B)inary or (S)record input mode <B> :
> Enter address offset  : <00400000 hex> :
> .512.1024..2048...
> Total bytes = 1839078 in 9948811 uSecs

Pls check your LINUX kernel format.As you set in the
configuation,image format is NetBin.But it seemed that
you downloaded ELF kernel.Pls try zImage.embedded
rather than vmlinux.

Best regards,

Sam


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/