Change FEC and SCC1 sequence,But SCC1 not work?

[Mark Chambers]

I notice that the MAC and IP for eth0 and eth1 are the same in the ifconfig
dump.

----- Original Message -----
From: <hjzgq at sohu.com>
To: <linuxppc-embedded at lists.linuxppc.org>
Sent: Thursday, June 10, 2004 5:12 AM
Subject: Change FEC and SCC1 sequence,But SCC1 not work?


>
> Hi all,
>
> I'm having a peculiar problem.
>
> Briefly, my platform is MPC860T from Motorola. I'm using ppcboot 1.1.16
> to tftp the kernel 2.4.4 through FEC and then load NFS/RAMDISK. If I
> configure the kernel with only FEC, then everything works well(NFS
> works and ping through eth0 works). If I configure the kernel with both
> FEC(as eth0) and SCC1(as eth1),it works well too,but when I configure
> ther kernel with both SCC1(eth0) and FEC(as eth1) (net/setup.c)! . I
> try to ping out through FEC(eth1), I get ring buffer dumps and no ping
> response:
>
> NETDEV WATCHDOG: eth1: transmit timed out
> eth1: transmit timed out.
> Ring data dump: cur_tx c1fa8100, tx_free 0, dirty_tx c1fa8100, cur_rx
> c1fa8020
> tx: 16 buffers
> c1fa8100: 9c00 002a 01f868c2
> c1fa8108: 9c00 002a 01f86842
> c1fa8110: 9c00 002a 01f867c2
> c1fa8118: 9c00 002a 01f86742
> c1fa8120: 9c00 002a 01f866c2
> c1fa8128: 9c00 002a 01f86642
> c1fa8130: 9c00 002a 01f865c2
> c1fa8138: 9c00 002a 01f86542
> c1fa8140: 9c00 002a 01f864c2
> c1fa8148: 9c00 002a 01f86442
> c1fa8150: 9c00 002a 01f863c2
> c1fa8158: 9c00 002a 01f86342
> c1fa8160: 9c00 002a 01f862c2
> c1fa8168: 9c00 002a 01dafbe2
> c1fa8170: 9c00 002a 01dafb62
> c1fa8178: bc00 002a 01dafce2
> rx: 32 buffers
> c1fa8000: 8880 0252 01fa7000
> c1fa8008: 8880 0040 01fa7800
> c1fa8010: 8880 0162 01fa6000
> c1fa8018: 8880 0040 01fa6800
> c1fa8020: 8000 0000 01fa5000
> c1fa8028: 8000 0000 01fa5800
> c1fa8030: 8000 0000 01fa4000
> c1fa8038: 8000 0000 01fa4800
> c1fa8040: 8000 0000 01fa3000
> c1fa8048: 8000 0000 01fa3800
> c1fa8050: 8000 0000 01fa2000
> c1fa8058: 8000 0000 01fa2800
> c1fa8060: 8000 0000 01fa1000
> c1fa8068: 8000 0000 01fa1800
> c1fa8070: 8000 0000 01fa0000
> c1fa8078: 8000 0000 01fa0800
> c1fa8080: 8000 0000 01f9f000
> c1fa8088: 8000 0000 01f9f800
> c1fa8090: 8000 0000 01f9e000
> c1fa8098: 8000 0000 01f9e800
> c1fa80a0: 8000 0000 01f9d000
> c1fa80a8: 8000 0000 01f9d800
> c1fa80b0: 8000 0000 01f9c000
> c1fa80b8: 8000 0000 01f9c800
> c1fa80c0: 8000 0000 01f9b000
> c1fa80c8: 8000 0000 01f9b800
> c1fa80d0: 8000 0000 01f9a000
> c1fa80d8: 8000 0000 01f9a800
> c1fa80e0: 8000 0000 01f99000
> c1fa80e8: 8000 0000 01f99800
> c1fa80f0: 8000 0000 01f98000
> c1fa80f8: a000 0000 01f98800
>
> Doing an ifconfig gives me......(TX errors continue to accumulate
> indefinitely even after I stop ping)
>
> eth0 Link encap:Ethernet HWaddr 00:02:87:55:66:77
> inet addr:199.199.199.129 Bcast:199.199.199.255
> Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:1538 errors:0 dropped:0 overruns:0 frame:0
> TX packets:698 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:100
> RX bytes:1787601 (1.7 Mb) TX bytes:102816 (100.4 kb)
> Base address:0x3c00
>
> eth1 Link encap:Ethernet HWaddr 00:02:87:D5:66:77
> inet addr:192.168.2.129 Bcast:192.168.2.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:4 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:5 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:100
> RX bytes:1076 (1.0 kb) TX bytes:672 (672.0 b)
> Base address:0xe00
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:21 errors:0 dropped:0 overruns:0 frame:0
> TX packets:21 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:2352 (2.2 kb) TX bytes:2352 (2.2 kb)
>
> Any help is deeply appreciated.
>
> Thanks
>
>


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/