U-Boot and kernel 2.6

[Meriin Michael-BMM063]

Check the bd_t definition, it MUST be the same in u-boot and Linux platform definition.
bd_t in Linux is defined in ppcboot.h

Best Regards,
     Michael Meriin


-----Original Message-----
From: owner-linuxppc-embedded at lists.linuxppc.org [mailto:owner-linuxppc-embedded at lists.linuxppc.org]On Behalf Of Ricardo DIz
Sent: Wednesday, June 09, 2004 20:48
To: linuxppc-embedded at lists.linuxppc.org
Subject: U-Boot and kernel 2.6



Hi,

I'm trying to boot a custom 860T board using the latest kernel from
linuxppc-2.5. The board is currently using a variation of an old version
of U-Boot (0.2.0) along with a hacked 2.4.20 linux kernel version.

My first aim is to boot a simple kernel and make it get to a shell. For
that I compiled the kernel, but did not compiled u-boot with a recent
version.

When booting, the kernel got uncompressed, but then it resets! I presume
the watchdog (which is enabled), is resetting the processor, so I guess
booting just stalls. Was there any changes in the way parameters were
received by the kernel since 2.4.20?

Oh, I forgot to mention the compiler. I'm still using a gcc 2.95
cross-compiler, altough I tried using a gcc 3.2 cross-compiler for the
8260 once, but got the same result.

I followed a recent thread very similar to this, but that turned out to be
just a matter of UART configuration, and I don't thinks this is the case.

Any thoughts?

Thanks in advance,
Ricardo Diz


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/