Problem debugging ppc kernel with DDD/GDB/BDI2000 on a custom MPC8260 board

Wolfgang Denk wd at denx.de
Thu Oct 16 03:56:27 EST 2003


Dear Joao,

in message <DEF39A0710293E489D45B10E06645CBD0243B3B2 at dub-msx1.spectelcorp.com> you wrote:
>
> on u-boot IMMR was set to 0x04700000, which is acceptable as far as
> u-boot is concerned, but not allowed once the kernel is initialised.
>
> The other issue was that the Chip Select was not configured properly on
> u-boot (2MB instead of 32MB), which was not noticed in u-boot since the
> u-boot never tried to access memory above that region, but caused the
> kernel to reset the target.
...
> I am using the denx distribution linuxppc_2_4_devel, and I am
> configuring it using the TQM8260 default configuration, customising some
> CPM settings for UART and FEC.

I would like to point out that you certainly did NOT pick up  such  a
bogus memory map from the TQM8260 default configuration, nor from any
other board maintened by DENX.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Old programmers never die, they just branch to a new address.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/





More information about the Linuxppc-embedded mailing list