kermit:How to disable the flow control signals?

rick.liu dovi at eyou.com
Sat May 17 15:18:24 EST 2003


Hi,
    I installed c-kermit209 in my linux,and copy the dot.kermrc
in the u-boot0.3.0 to ~/.kermrc,then connect the kermit to my direct
-serral port:

bash>wermit -c
Connecting to /dev/ttyS0, speed 115200
 Escape character: Ctrl-\ (ASCII 28, FS): enabled
Type the escape character followed by C to get back,
or followed by ? to see other options.
----------------------------------------------------
(and then ctrl_\ s)
Device: /dev/ttyS0
Speed 115200
 Terminal echo: remote
 Terminal bytesize: 8
 Command bytesize: 8
 Parity: none
 Autodownload: on
 Session log: (none)
 Carrier Detect      (CD):  On
 Dataset Ready       (DSR): On
 Clear To Send       (CTS): On
 Ring Indicator      (RI):  Off
 Data Terminal Ready (DTR): On
 Request To Send     (RTS): On

here is the question:
1.why the flow control signals are still "on"?
2.if I have a 3-wired smc1/serial port,how to configure
  to turn off RTS/CTS etc.?

Best regards
Thanks !!

Rick


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/





More information about the Linuxppc-embedded mailing list