Linux-2.4.18 on MPC860T -Linux kernel boot problem
Anil Giri
anil at india.tejasnetworks.com
Mon May 12 23:37:57 EST 2003
Hi everybody,
I'm trying to run a Linux kernel (2.4.18) on a Motorola MPC860T
processor.But my kernel boot hangs in my_console_write function in uart.c
I can't see any message on the console after "Now booting the kernel".
My question is, has anyone been able to boot a 2.4.18 kernel on an
MPC860T, using PPCBoot as the boot loader ? If so, have you encountered such a
problem ? Is there any issue with clock freq. in Hz instead of Mhz.?
Is there any patch available for ppc?
Following is the output on console...
=========================================
Initializing...
CPU: XPC860xxZPnnD4 at 66 MHz: 4 kB I-Cache 4 kB D-Cache FEC present
Board: 103-PCALTC101-E AF-4402-20-0041
Ethernet Address : 00:04:95:05:00:0e
1/ 2/ 0 3: 7:25
DRAM: (128 MB SDRAM) 128 MB
FLASH: 16 MB
*** Warning - bad CRC, using default environment
Input: serial
Output: serial
Hit any key to stop autoboot: 0
## Starting application at 0x40080000 ...
loaded at: 40080000 40089368
relocated to: 00180000 00189368
board data at: 07F3FE48 07F40000
relocated to: 00200100 002002B8
zimage at: 40086000 4010A956
initrd at: 4010A956 40360A1A
relocated to: 07DA9000 07FFF0C4
avail ram: 00201000 07DA9000
Linux/PPC load: root=/dev/ram
Uncompressing Linux...done.
Now booting the kernel
=========================================
-Anil
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
More information about the Linuxppc-embedded
mailing list