EP405 network interface

Toni Van Remortel t.vanremortel at ha.be
Thu Jul 3 00:25:24 EST 2003


How and where?

I found that the PHY address in the manual is 0b00000 and in the code
PPC405_PCI_PHY_MEM_BASE is set to 0x80000000.


Op do 26-06-2003, om 20:39 schreef Steven Blakeslee:
> Did you enable the phy in the Board Control Status Register?
>
> -----Original Message-----
> From: Toni Van Remortel [mailto:t.vanremortel at ha.be]
> Sent: Thursday, June 26, 2003 10:01 AM
> To: PPC Mailinglist
> Subject: EP405 network interface
>
>
>
> Hi all,
>
> I cannot get the NIC working on my EP405. I used the ep405_config from
> the linuxppc_2_4_devel tree.
>
> This is a part of the output:
>
> ...
> loop: loaded (max 8 devices)
> eth0: No PHY device found.
> removing net dev
> ...
>
> So it seems that the kernel doesn't find the NIC (but it is there, and
> working, ep-bootloader can use it to download the image).
>
> Anybody an idea?
>
> I already checked the NIC support, and the onboard-IBM NIC support is
> enabled.
>
> Regards,
> --
>                            Toni Van Remortel
>               Wetenschappelijk Medewerker - D-science lab
>                  Tel: 03 205 61 72 - Fax: 03 205 61 95
>                       E-mail: t.vanremortel at ha.be
>
>
>


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/





More information about the Linuxppc-embedded mailing list