Boot Loader

[Wolfgang Denk]

Dear Kevin,

in message <3FE6DCB3.109 at catapult.com> you wrote:
>
> For my end target I have to boot across a shared memory
> interface by placing the executable into RAM.  This is
> part of a multi processor system where the Linux board
> is a cPCI slave.  The Linux board will not have a flash
> or a network connection.  I is held in reset by the master
> until the s/w is loaded and then released.  This is an 8275

This has been done before. See for example the  "PN62"  configuration
in U-Boot.

> Any suggestions on how to do this ?

Use U-Boot...

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
It all seemed, he thought, to be rather a lot of  trouble  to  go  to
just sharpen a razor blade.  - Terry Pratchett, _The Light Fantastic_

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/