ifconfig: SCC1 enet0 not showing up
Wolfgang Denk
wd at denx.de
Thu Dec 19 03:43:12 EST 2002
In message <DB0585C9F6F9D411BE8F00D0B7896A4CC05F4E at SNCMAIL> you wrote:
>
> My Ethernet is not showing up ... I have compiled in enet support ... fixed
> my port pins ... but when I do ifconfig I see only:
Probably you did not configure the network interface at all?
> At start my enet scc is configured properly ... I am pretty sure because I
> see:
> ## Transferring control to Linux (at address 00000000) ...
> Linux version 2.4.20-pre8 ...
> Kernel command line: root=/dev/ram rw
> ip=192.168.104.101:192.168.103.151:192.168.104.1:255.255.255.0:BigMoney::off
>From this command line I suspect that you intend to use IP
autoconfiguration, but then...
...
> CONFIG_INET=y
> CONFIG_IP_MULTICAST=y
> # CONFIG_IP_ADVANCED_ROUTER is not set
> # CONFIG_IP_PNP is not set
^^^^^^^^^^^^^^^^^^^^^^^^^^^^
...then you don't enable IP autoconfiguration in the kernel, so you
will have to manually configure the interface.
I guess you want to define CONFIG_IP_PNP ...
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de
Why is an average signature file longer than an average Perl script??
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
More information about the Linuxppc-embedded
mailing list