Cannot boot properly

[Wolfgang Denk]

Dear Jon,

in message <3CADD870.4050200 at control.auc.dk> you wrote:
>
> >If this i the case, you have mis-configured the  serial  ports.  Make
> >sure  to  enable  both SMC1 and SMC2 in the kernel configuration, and
> >select the right one as console port. Also make sure that you  select
> >CONFIG_ALTSMC2.
> >
>
> Done that and now it works !!

Congratulations!

> Thank you for your quick response

You're welcome!

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Use C++ to confuse your enemies; use C to produce stable code.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/