SysVInit (RC Scripts) on HHL 2.0 (Add'n info)

[Mark Hatle]

Mark Hatle wrote:
>
> James F Dougherty wrote:
>
> > I am using HHL 2.0 (2.4.2) on MPC8240 and I downloaded
> > the root filesystem RPM's from
> >
> > ftp://ftp.mvista.com/pub/Journeyman/cd2/ppc_82xx/apps/*.rpm
> >
> > Is there some bug in HHL 2.0 on ppc_82xx I don't know about?
>
> Assuming you used the installer, only the init scripts required to boot
> a minimal system (and be able to telnet in and use nfs root) are
> enabled.  Anything beyond that you, the developer/user will need to
> enable.  If you did not use the installer, you probably got a bunch of
> messages during installation such as "Unable to enable initd service:
> checkfs.sh".  These messages mean that the initdconfig program was not
> able to be run for some reason or another, thus you probably don't have
> ANY initscripts installed.
>
> The initscripts are further discussed in the "Initscript Overview"
> section of Chapter 7.

FYI, if you did not use the installer, and want to try to "rescue" your
installation, the following initscripts are enabled by default in the
installer.  (If I list an initscript you don't have ignore it, it isn't
part of Journeyman then.)

bootmisc.sh    	S:on
checkfs.sh     	S:on
checkroot.sh   	S:on
devpts.sh      	S:on
mountall.sh    	S:on
mountnfs.sh    	S:on
umountfs       		0:on						6:on
umountnfs.sh   		0:on						6:on
ifupdown       	S:on
networking     	S:on
inetd          				2:on	3:on	4:on	5:on
portmap        	S:on
syslog         				2:on	3:on	4:on	5:on

--Mark Hatle
MontaVista Software, Inc.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/