[PATCH v9 4/5] PCI: dwc: ep: Support BAR subrange inbound mapping via Address Match Mode iATU

[Niklas Cassel]

On Fri, Jan 23, 2026 at 10:16:21AM +0900, Koichiro Den wrote:
> >
> > There might be other EPC drivers that don't disable all BARs in their .init(), so I would say that simply checking if the BAR has an address is not sufficient to guarantee that an EPF driver has called set_bar().
> >
>
> Even if an EPC driver does not reset the BAR in their .init() and some
> default translation is left exposed, wouldn't it be safe as long as
> dw_pcie_ep_ib_atu_addr() succeeds in programming inbound mappings for the
> entire BAR?

For e.g. on RK3588, the default HW configuration of the DWC controller has
all 5 BARs as enabled, with a size of 1 GB.

There is no inbound address translation for these BARs by default.

So for it to be safe, the size of the set_bar() call would have to
match the current size of the BAR, but how should the EPF driver know
that when it has not called set_bar() yet?

dw_pcie_ep_read_bar_assigned() does not return the current size of the
BAR. So you can't verify that the set_bar() call has the same size as
the BARs "default size".


>
> That said, such usage apparently contradicts the documented usage (1st
> set_bar with no submap, then with submap) described in the docs and commit
> messages in this series, and allowing it would make things unnecessarily
> complicated. So I agree that adding such a safeguard is the right approach.
>
> >
> > I think the safest option is my second suggestion because then we know that we will only call
> > dw_pcie_ep_ib_atu_addr()
> >
> > When:
> >
> > 1) If ep->epf_bar[bar] is set:
> > https://github.com/torvalds/linux/blob/v6.19-rc6/drivers/pci/controller/dwc/pcie-designware-ep.c#L363
> >
> >
> > 2) All the other requirements to dynamically update a BAR is also met:
> >
> > https://github.com/torvalds/linux/blob/v6.19-rc6/drivers/pci/controller/dwc/pcie-designware-ep.c#L368-L370
> >
>
> That makes sense, and it ensures that the behavior always accords with the
> docs and commit messages in this series.

I think it makes most sense to put the "use_addr_translation = true"

after the check:

		/*
		 * We can only dynamically change a BAR if the new BAR size and
		 * BAR flags do not differ from the existing configuration.
		 */
		if (ep->epf_bar[bar]->barno != bar ||
		    ep->epf_bar[bar]->size != size ||
		    ep->epf_bar[bar]->flags != flags)
			return -EINVAL;


So we know that dw_pcie_ep_ib_atu_addr() is only called when the size is the
same.


Kind regards,
Niklas