[PATCH bpf v2] powerpc/bpf: enforce full ordering for ATOMIC operations with BPF_FETCH

Christophe Leroy christophe.leroy at csgroup.eu
Mon May 13 16:18:04 AEST 2024



Le 08/05/2024 à 13:54, Puranjay Mohan a écrit :
> [Vous ne recevez pas souvent de courriers de puranjay at kernel.org. Découvrez pourquoi ceci est important à https://aka.ms/LearnAboutSenderIdentification ]
> 
> The Linux Kernel Memory Model [1][2] requires RMW operations that have a
> return value to be fully ordered.
> 
> BPF atomic operations with BPF_FETCH (including BPF_XCHG and
> BPF_CMPXCHG) return a value back so they need to be JITed to fully
> ordered operations. POWERPC currently emits relaxed operations for
> these.
> 
> We can show this by running the following litmus-test:
> 
> PPC SB+atomic_add+fetch
> 
> {
> 0:r0=x;  (* dst reg assuming offset is 0 *)
> 0:r1=2;  (* src reg *)
> 0:r2=1;
> 0:r4=y;  (* P0 writes to this, P1 reads this *)
> 0:r5=z;  (* P1 writes to this, P0 reads this *)
> 0:r6=0;
> 
> 1:r2=1;
> 1:r4=y;
> 1:r5=z;
> }
> 
> P0                      | P1            ;
> stw         r2, 0(r4)   | stw  r2,0(r5) ;
>                          |               ;
> loop:lwarx  r3, r6, r0  |               ;
> mr          r8, r3      |               ;
> add         r3, r3, r1  | sync          ;
> stwcx.      r3, r6, r0  |               ;
> bne         loop        |               ;
> mr          r1, r8      |               ;
>                          |               ;
> lwa         r7, 0(r5)   | lwa  r7,0(r4) ;
> 
> ~exists(0:r7=0 /\ 1:r7=0)
> 
> Witnesses
> Positive: 9 Negative: 3
> Condition ~exists (0:r7=0 /\ 1:r7=0)
> Observation SB+atomic_add+fetch Sometimes 3 9
> 
> This test shows that the older store in P0 is reordered with a newer
> load to a different address. Although there is a RMW operation with
> fetch between them. Adding a sync before and after RMW fixes the issue:
> 
> Witnesses
> Positive: 9 Negative: 0
> Condition ~exists (0:r7=0 /\ 1:r7=0)
> Observation SB+atomic_add+fetch Never 0 9
> 
> [1] https://www.kernel.org/doc/Documentation/memory-barriers.txt
> [2] https://www.kernel.org/doc/Documentation/atomic_t.txt
> 
> Fixes: 65112709115f ("powerpc/bpf/64: add support for BPF_ATOMIC bitwise operations")
> Signed-off-by: Puranjay Mohan <puranjay at kernel.org>
> ---
> Changes in v1 -> v2:
> v1: https://lore.kernel.org/all/20240507175439.119467-1-puranjay@kernel.org/
> - Don't emit `sync` for non-SMP kernels as that adds unessential overhead.
> ---
>   arch/powerpc/net/bpf_jit_comp32.c | 12 ++++++++++++
>   arch/powerpc/net/bpf_jit_comp64.c | 12 ++++++++++++
>   2 files changed, 24 insertions(+)
> 
> diff --git a/arch/powerpc/net/bpf_jit_comp32.c b/arch/powerpc/net/bpf_jit_comp32.c
> index 2f39c50ca729..0318b83f2e6a 100644
> --- a/arch/powerpc/net/bpf_jit_comp32.c
> +++ b/arch/powerpc/net/bpf_jit_comp32.c
> @@ -853,6 +853,15 @@ int bpf_jit_build_body(struct bpf_prog *fp, u32 *image, u32 *fimage, struct code
>                          /* Get offset into TMP_REG */
>                          EMIT(PPC_RAW_LI(tmp_reg, off));
>                          tmp_idx = ctx->idx * 4;
> +                       /*
> +                        * Enforce full ordering for operations with BPF_FETCH by emitting a 'sync'
> +                        * before and after the operation.
> +                        *
> +                        * This is a requirement in the Linux Kernel Memory Model.
> +                        * See __cmpxchg_u64() in asm/cmpxchg.h as an example.

You mean __cmpxchg_u32() ?

> +                        */
> +                       if (imm & BPF_FETCH && IS_ENABLED(CONFIG_SMP))

Please enclose imm & BPF_FETCH inside a () to improve readability.

> +                               EMIT(PPC_RAW_SYNC());

Do you really want to do it inside the loop at each try ? Because when 
stwcx. fails it jumps back at tmp_idx which is your new sync now.

>                          /* load value from memory into r0 */
>                          EMIT(PPC_RAW_LWARX(_R0, tmp_reg, dst_reg, 0));
> 
> @@ -905,6 +914,9 @@ int bpf_jit_build_body(struct bpf_prog *fp, u32 *image, u32 *fimage, struct code
> 
>                          /* For the BPF_FETCH variant, get old data into src_reg */
>                          if (imm & BPF_FETCH) {
> +                               /* Emit 'sync' to enforce full ordering */
> +                               if (IS_ENABLED(CONFIG_SMP))
> +                                       EMIT(PPC_RAW_SYNC());
>                                  EMIT(PPC_RAW_MR(ret_reg, ax_reg));
>                                  if (!fp->aux->verifier_zext)
>                                          EMIT(PPC_RAW_LI(ret_reg - 1, 0)); /* higher 32-bit */
> diff --git a/arch/powerpc/net/bpf_jit_comp64.c b/arch/powerpc/net/bpf_jit_comp64.c
> index 79f23974a320..9a077f8acf7b 100644
> --- a/arch/powerpc/net/bpf_jit_comp64.c
> +++ b/arch/powerpc/net/bpf_jit_comp64.c
> @@ -804,6 +804,15 @@ int bpf_jit_build_body(struct bpf_prog *fp, u32 *image, u32 *fimage, struct code
>                          /* Get offset into TMP_REG_1 */
>                          EMIT(PPC_RAW_LI(tmp1_reg, off));
>                          tmp_idx = ctx->idx * 4;
> +                       /*
> +                        * Enforce full ordering for operations with BPF_FETCH by emitting a 'sync'
> +                        * before and after the operation.
> +                        *
> +                        * This is a requirement in the Linux Kernel Memory Model.
> +                        * See __cmpxchg_u64() in asm/cmpxchg.h as an example.
> +                        */
> +                       if (imm & BPF_FETCH && IS_ENABLED(CONFIG_SMP))

Please enclose imm & BPF_FETCH inside a () to improve readability.


> +                               EMIT(PPC_RAW_SYNC());

Same, the sync should be outside the loop I guess.

>                          /* load value from memory into TMP_REG_2 */
>                          if (size == BPF_DW)
>                                  EMIT(PPC_RAW_LDARX(tmp2_reg, tmp1_reg, dst_reg, 0));
> @@ -865,6 +874,9 @@ int bpf_jit_build_body(struct bpf_prog *fp, u32 *image, u32 *fimage, struct code
>                          PPC_BCC_SHORT(COND_NE, tmp_idx);
> 
>                          if (imm & BPF_FETCH) {
> +                               /* Emit 'sync' to enforce full ordering */
> +                               if (IS_ENABLED(CONFIG_SMP))
> +                                       EMIT(PPC_RAW_SYNC());
>                                  EMIT(PPC_RAW_MR(ret_reg, _R0));
>                                  /*
>                                   * Skip unnecessary zero-extension for 32-bit cmpxchg.
> --
> 2.42.0
> 


More information about the Linuxppc-dev mailing list