[PATCH v8 08/10] PCI: dwc: ep: Add a generic dw_pcie_ep_linkdown() API to handle LINK_DOWN event
Manivannan Sadhasivam
manivannan.sadhasivam at linaro.org
Tue Feb 27 23:30:24 AEDT 2024
On Mon, Feb 26, 2024 at 12:18:18PM -0500, Frank Li wrote:
> On Sat, Feb 24, 2024 at 12:24:14PM +0530, Manivannan Sadhasivam wrote:
> > The PCIe link can go to LINK_DOWN state in one of the following scenarios:
> >
> > 1. Fundamental (PERST#)/hot/warm reset
> > 2. Link transition from L2/L3 to L0
>
> From L0 to L2/l3
>
I don't understand what you mean here. Link down won't happen while moving from
L0 to L2/L3, it is the opposite.
> >
> > In those cases, LINK_DOWN causes some non-sticky DWC registers to loose the
> > state (like REBAR, PTM_CAP etc...). So the drivers need to reinitialize
> > them to function properly once the link comes back again.
> >
> > This is not a problem for drivers supporting PERST# IRQ, since they can
> > reinitialize the registers in the PERST# IRQ callback. But for the drivers
> > not supporting PERST#, there is no way they can reinitialize the registers
> > other than relying on LINK_DOWN IRQ received when the link goes down. So
> > let's add a DWC generic API dw_pcie_ep_linkdown() that reinitializes the
> > non-sticky registers and also notifies the EPF drivers about link going
> > down.
> >
> > This API can also be used by the drivers supporting PERST# to handle the
> > scenario (2) mentioned above.
> >
> > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
> > ---
> > drivers/pci/controller/dwc/pcie-designware-ep.c | 111 ++++++++++++++----------
> > drivers/pci/controller/dwc/pcie-designware.h | 5 ++
> > 2 files changed, 72 insertions(+), 44 deletions(-)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-designware-ep.c b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > index 278bdc9b2269..fed4c2936c78 100644
> > --- a/drivers/pci/controller/dwc/pcie-designware-ep.c
> > +++ b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > @@ -14,14 +14,6 @@
> > #include <linux/pci-epc.h>
> > #include <linux/pci-epf.h>
> >
> > -void dw_pcie_ep_linkup(struct dw_pcie_ep *ep)
> > -{
> > - struct pci_epc *epc = ep->epc;
> > -
> > - pci_epc_linkup(epc);
> > -}
> > -EXPORT_SYMBOL_GPL(dw_pcie_ep_linkup);
> > -
>
> No sure why git remove this block and add these back.
>
Because, we are adding dw_pcie_ep_linkdown() API way below and it makes sense to
move this API also to keep it ordered. Maybe I should've described it in commit
message.
- Mani
>
> > void dw_pcie_ep_init_notify(struct dw_pcie_ep *ep)
> > {
> > struct pci_epc *epc = ep->epc;
> > @@ -603,19 +595,56 @@ static unsigned int dw_pcie_ep_find_ext_capability(struct dw_pcie *pci, int cap)
> > return 0;
> > }
> >
> > +static void dw_pcie_ep_init_non_sticky_registers(struct dw_pcie *pci)
> > +{
> > + unsigned int offset, ptm_cap_base;
> > + unsigned int nbars;
> > + u32 reg, i;
> > +
> > + offset = dw_pcie_ep_find_ext_capability(pci, PCI_EXT_CAP_ID_REBAR);
> > + ptm_cap_base = dw_pcie_ep_find_ext_capability(pci, PCI_EXT_CAP_ID_PTM);
> > +
> > + dw_pcie_dbi_ro_wr_en(pci);
> > +
> > + if (offset) {
> > + reg = dw_pcie_readl_dbi(pci, offset + PCI_REBAR_CTRL);
> > + nbars = (reg & PCI_REBAR_CTRL_NBAR_MASK) >>
> > + PCI_REBAR_CTRL_NBAR_SHIFT;
> > +
> > + for (i = 0; i < nbars; i++, offset += PCI_REBAR_CTRL)
> > + dw_pcie_writel_dbi(pci, offset + PCI_REBAR_CAP, 0x0);
> > + }
> > +
> > + /*
> > + * PTM responder capability can be disabled only after disabling
> > + * PTM root capability.
> > + */
> > + if (ptm_cap_base) {
> > + dw_pcie_dbi_ro_wr_en(pci);
> > + reg = dw_pcie_readl_dbi(pci, ptm_cap_base + PCI_PTM_CAP);
> > + reg &= ~PCI_PTM_CAP_ROOT;
> > + dw_pcie_writel_dbi(pci, ptm_cap_base + PCI_PTM_CAP, reg);
> > +
> > + reg = dw_pcie_readl_dbi(pci, ptm_cap_base + PCI_PTM_CAP);
> > + reg &= ~(PCI_PTM_CAP_RES | PCI_PTM_GRANULARITY_MASK);
> > + dw_pcie_writel_dbi(pci, ptm_cap_base + PCI_PTM_CAP, reg);
> > + dw_pcie_dbi_ro_wr_dis(pci);
> > + }
> > +
> > + dw_pcie_setup(pci);
> > + dw_pcie_dbi_ro_wr_dis(pci);
> > +}
> > +
> > int dw_pcie_ep_init_registers(struct dw_pcie_ep *ep)
> > {
> > struct dw_pcie *pci = to_dw_pcie_from_ep(ep);
> > struct dw_pcie_ep_func *ep_func;
> > struct device *dev = pci->dev;
> > struct pci_epc *epc = ep->epc;
> > - unsigned int offset, ptm_cap_base;
> > - unsigned int nbars;
> > u8 hdr_type;
> > u8 func_no;
> > - int i, ret;
> > void *addr;
> > - u32 reg;
> > + int ret;
> >
> > hdr_type = dw_pcie_readb_dbi(pci, PCI_HEADER_TYPE) &
> > PCI_HEADER_TYPE_MASK;
> > @@ -678,38 +707,7 @@ int dw_pcie_ep_init_registers(struct dw_pcie_ep *ep)
> > if (ep->ops->init)
> > ep->ops->init(ep);
> >
> > - offset = dw_pcie_ep_find_ext_capability(pci, PCI_EXT_CAP_ID_REBAR);
> > - ptm_cap_base = dw_pcie_ep_find_ext_capability(pci, PCI_EXT_CAP_ID_PTM);
> > -
> > - dw_pcie_dbi_ro_wr_en(pci);
> > -
> > - if (offset) {
> > - reg = dw_pcie_readl_dbi(pci, offset + PCI_REBAR_CTRL);
> > - nbars = (reg & PCI_REBAR_CTRL_NBAR_MASK) >>
> > - PCI_REBAR_CTRL_NBAR_SHIFT;
> > -
> > - for (i = 0; i < nbars; i++, offset += PCI_REBAR_CTRL)
> > - dw_pcie_writel_dbi(pci, offset + PCI_REBAR_CAP, 0x0);
> > - }
> > -
> > - /*
> > - * PTM responder capability can be disabled only after disabling
> > - * PTM root capability.
> > - */
> > - if (ptm_cap_base) {
> > - dw_pcie_dbi_ro_wr_en(pci);
> > - reg = dw_pcie_readl_dbi(pci, ptm_cap_base + PCI_PTM_CAP);
> > - reg &= ~PCI_PTM_CAP_ROOT;
> > - dw_pcie_writel_dbi(pci, ptm_cap_base + PCI_PTM_CAP, reg);
> > -
> > - reg = dw_pcie_readl_dbi(pci, ptm_cap_base + PCI_PTM_CAP);
> > - reg &= ~(PCI_PTM_CAP_RES | PCI_PTM_GRANULARITY_MASK);
> > - dw_pcie_writel_dbi(pci, ptm_cap_base + PCI_PTM_CAP, reg);
> > - dw_pcie_dbi_ro_wr_dis(pci);
> > - }
> > -
> > - dw_pcie_setup(pci);
> > - dw_pcie_dbi_ro_wr_dis(pci);
> > + dw_pcie_ep_init_non_sticky_registers(pci);
> >
> > return 0;
> >
> > @@ -720,6 +718,31 @@ int dw_pcie_ep_init_registers(struct dw_pcie_ep *ep)
> > }
> > EXPORT_SYMBOL_GPL(dw_pcie_ep_init_registers);
> >
> > +void dw_pcie_ep_linkup(struct dw_pcie_ep *ep)
> > +{
> > + struct pci_epc *epc = ep->epc;
> > +
> > + pci_epc_linkup(epc);
> > +}
> > +EXPORT_SYMBOL_GPL(dw_pcie_ep_linkup);
> > +
> > +void dw_pcie_ep_linkdown(struct dw_pcie_ep *ep)
> > +{
> > + struct dw_pcie *pci = to_dw_pcie_from_ep(ep);
> > + struct pci_epc *epc = ep->epc;
> > +
> > + /*
> > + * Initialize the non-sticky DWC registers as they would've reset post
> > + * LINK_DOWN. This is specifically needed for drivers not supporting
> > + * PERST# as they have no way to reinitialize the registers before the
> > + * link comes back again.
> > + */
> > + dw_pcie_ep_init_non_sticky_registers(pci);
> > +
> > + pci_epc_linkdown(epc);
> > +}
> > +EXPORT_SYMBOL_GPL(dw_pcie_ep_linkdown);
> > +
> > int dw_pcie_ep_init(struct dw_pcie_ep *ep)
> > {
> > int ret;
> > diff --git a/drivers/pci/controller/dwc/pcie-designware.h b/drivers/pci/controller/dwc/pcie-designware.h
> > index f8e5431a207b..152969545b0a 100644
> > --- a/drivers/pci/controller/dwc/pcie-designware.h
> > +++ b/drivers/pci/controller/dwc/pcie-designware.h
> > @@ -668,6 +668,7 @@ static inline void __iomem *dw_pcie_own_conf_map_bus(struct pci_bus *bus,
> >
> > #ifdef CONFIG_PCIE_DW_EP
> > void dw_pcie_ep_linkup(struct dw_pcie_ep *ep);
> > +void dw_pcie_ep_linkdown(struct dw_pcie_ep *ep);
> > int dw_pcie_ep_init(struct dw_pcie_ep *ep);
> > int dw_pcie_ep_init_registers(struct dw_pcie_ep *ep);
> > void dw_pcie_ep_init_notify(struct dw_pcie_ep *ep);
> > @@ -688,6 +689,10 @@ static inline void dw_pcie_ep_linkup(struct dw_pcie_ep *ep)
> > {
> > }
> >
> > +static inline void dw_pcie_ep_linkdown(struct dw_pcie_ep *ep)
> > +{
> > +}
> > +
> > static inline int dw_pcie_ep_init(struct dw_pcie_ep *ep)
> > {
> > return 0;
> >
> > --
> > 2.25.1
> >
--
மணிவண்ணன் சதாசிவம்
More information about the Linuxppc-dev
mailing list