[Bisected] PowerMac G5 fails booting kernel 6.6-rc3 (BUG: Unable to handle kernel data access at 0xfeffbb62ffec65fe)

[Aneesh Kumar K.V]

Hi,

Erhard Furtner <erhard_f at mailbox.org> writes:

> Greetings!
>
> Kernel 6.5.5 boots fine on my PowerMac G5 11,2 but kernel 6.6-rc3 fails to boot with following dmesg shown on the OpenFirmware console (transcribed screenshot):

> I bisected the issue and got 9fee28baa601f4dbf869b1373183b312d2d5ef3d as 1st bad commit:
>

Can you check this change?

diff --git a/arch/powerpc/mm/pgtable.c b/arch/powerpc/mm/pgtable.c
index 3ba9fe411604..6d144fedd557 100644
--- a/arch/powerpc/mm/pgtable.c
+++ b/arch/powerpc/mm/pgtable.c
@@ -187,8 +187,8 @@ static pte_t set_access_flags_filter(pte_t pte, struct vm_area_struct *vma,
 /*
  * set_pte stores a linux PTE into the linux page table.
  */
-void set_ptes(struct mm_struct *mm, unsigned long addr, pte_t *ptep,
-		pte_t pte, unsigned int nr)
+static void set_pte_at(struct mm_struct *mm, unsigned long addr, pte_t *ptep,
+		pte_t pte)
 {
 	/*
 	 * Make sure hardware valid bit is not set. We don't do
@@ -203,16 +203,23 @@ void set_ptes(struct mm_struct *mm, unsigned long addr, pte_t *ptep,
 	pte = set_pte_filter(pte);
 
 	/* Perform the setting of the PTE */
-	arch_enter_lazy_mmu_mode();
+	__set_pte_at(mm, addr, ptep, pte, 0);
+}
+
+/*
+ * set_pte stores a linux PTE into the linux page table.
+ */
+void set_ptes(struct mm_struct *mm, unsigned long addr, pte_t *ptep,
+		pte_t pte, unsigned int nr)
+{
+	/* Perform the setting of the PTE */
 	for (;;) {
-		__set_pte_at(mm, addr, ptep, pte, 0);
+		set_pte_at(mm, addr, ptep, pte);
 		if (--nr == 0)
 			break;
 		ptep++;
-		pte = __pte(pte_val(pte) + (1UL << PTE_RPN_SHIFT));
 		addr += PAGE_SIZE;
 	}
-	arch_leave_lazy_mmu_mode();
 }
 
 void unmap_kernel_page(unsigned long va)