[PATCH v2 4/6] watchdog/hardlockup: Make HAVE_NMI_WATCHDOG sparc64-specific
Petr Mladek
pmladek at suse.com
Sat Jun 17 01:06:16 AEST 2023
There are several hardlockup detector implementations and several Kconfig
values which allow selection and build of the preferred one.
CONFIG_HARDLOCKUP_DETECTOR was introduced by the commit 23637d477c1f53acb
("lockup_detector: Introduce CONFIG_HARDLOCKUP_DETECTOR") in v2.6.36.
It was a preparation step for introducing the new generic perf hardlockup
detector.
The existing arch-specific variants did not support the to-be-created
generic build configurations, sysctl interface, etc. This distinction
was made explicit by the commit 4a7863cc2eb5f98 ("x86, nmi_watchdog:
Remove ARCH_HAS_NMI_WATCHDOG and rely on CONFIG_HARDLOCKUP_DETECTOR")
in v2.6.38.
CONFIG_HAVE_NMI_WATCHDOG was introduced by the commit d314d74c695f967e105
("nmi watchdog: do not use cpp symbol in Kconfig") in v3.4-rc1. It replaced
the above mentioned ARCH_HAS_NMI_WATCHDOG. At that time, it was still used
by three architectures, namely blackfin, mn10300, and sparc.
The support for blackfin and mn10300 architectures has been completely
dropped some time ago. And sparc is the only architecture with the historic
NMI watchdog at the moment.
And the old sparc implementation is really special. It is always built on
sparc64. It used to be always enabled until the commit 7a5c8b57cec93196b
("sparc: implement watchdog_nmi_enable and watchdog_nmi_disable") added
in v4.10-rc1.
There are only few locations where the sparc64 NMI watchdog interacts
with the generic hardlockup detectors code:
+ implements arch_touch_nmi_watchdog() which is called from the generic
touch_nmi_watchdog()
+ implements watchdog_hardlockup_enable()/disable() to support
/proc/sys/kernel/nmi_watchdog
+ is always preferred over other generic watchdogs, see
CONFIG_HARDLOCKUP_DETECTOR
+ includes asm/nmi.h into linux/nmi.h because some sparc-specific
functions are needed in sparc-specific code which includes
only linux/nmi.h.
The situation became more complicated after the commit 05a4a95279311c3
("kernel/watchdog: split up config options") and commit 2104180a53698df5
("powerpc/64s: implement arch-specific hardlockup watchdog") in v4.13-rc1.
They introduced HAVE_HARDLOCKUP_DETECTOR_ARCH. It was used for powerpc
specific hardlockup detector. It was compatible with the perf one
regarding the general boot, sysctl, and programming interfaces.
HAVE_HARDLOCKUP_DETECTOR_ARCH was defined as a superset of
HAVE_NMI_WATCHDOG. It made some sense because all arch-specific
detectors had some common requirements, namely:
+ implemented arch_touch_nmi_watchdog()
+ included asm/nmi.h into linux/nmi.h
+ defined the default value for /proc/sys/kernel/nmi_watchdog
But it actually has made things pretty complicated when the generic
buddy hardlockup detector was added. Before the generic perf detector
was newer supported together with an arch-specific one. But the buddy
detector could work on any SMP system. It means that an architecture
could support both the arch-specific and buddy detector.
As a result, there are few tricky dependencies. For example,
CONFIG_HARDLOCKUP_DETECTOR depends on:
((HAVE_HARDLOCKUP_DETECTOR_PERF || HAVE_HARDLOCKUP_DETECTOR_BUDDY) && !HAVE_NMI_WATCHDOG) || HAVE_HARDLOCKUP_DETECTOR_ARCH
The problem is that the very special sparc implementation is defined as:
HAVE_NMI_WATCHDOG && !HAVE_HARDLOCKUP_DETECTOR_ARCH
Another problem is that the meaning of HAVE_NMI_WATCHDOG is far from clear
without reading understanding the history.
Make the logic less tricky and more self-explanatory by making
HAVE_NMI_WATCHDOG specific for the sparc64 implementation. And rename it to
HAVE_HARDLOCKUP_DETECTOR_SPARC64.
Note that HARDLOCKUP_DETECTOR_PREFER_BUDDY, HARDLOCKUP_DETECTOR_PERF,
and HARDLOCKUP_DETECTOR_BUDDY may conflict only with
HAVE_HARDLOCKUP_DETECTOR_ARCH. They depend on HARDLOCKUP_DETECTOR
and it is not longer enabled when HAVE_NMI_WATCHDOG is set.
Signed-off-by: Petr Mladek <pmladek at suse.com>
watchdog/sparc64: Rename HAVE_NMI_WATCHDOG to HAVE_HARDLOCKUP_WATCHDOG_SPARC64
The configuration variable HAVE_NMI_WATCHDOG has a generic name but
it is selected only for SPARC64.
It should _not_ be used in general because it is not integrated with
the other hardlockup detectors. Namely, it does not support the hardlockup
specific command line parameters and systcl interface. Instead, it is
enabled/disabled together with the softlockup detector by the global
"watchdog" sysctl.
Rename it to HAVE_HARDLOCKUP_WATCHDOG_SPARC64 to make the special
behavior more clear.
Also the variable is set only on sparc64. Move the definition
from arch/Kconfig to arch/sparc/Kconfig.debug.
Signed-off-by: Petr Mladek <pmladek at suse.com>
---
arch/Kconfig | 18 ------------------
arch/sparc/Kconfig | 2 +-
arch/sparc/Kconfig.debug | 9 +++++++++
include/linux/nmi.h | 5 ++---
kernel/watchdog.c | 2 +-
lib/Kconfig.debug | 15 +++++----------
6 files changed, 18 insertions(+), 33 deletions(-)
diff --git a/arch/Kconfig b/arch/Kconfig
index 77e5af5fda3f..6517e5477459 100644
--- a/arch/Kconfig
+++ b/arch/Kconfig
@@ -400,23 +400,8 @@ config HAVE_HARDLOCKUP_DETECTOR_PERF
The arch chooses to use the generic perf-NMI-based hardlockup
detector. Must define HAVE_PERF_EVENTS_NMI.
-config HAVE_NMI_WATCHDOG
- depends on HAVE_NMI
- bool
- help
- The arch provides its own hardlockup detector implementation instead
- of the generic ones.
-
- Sparc64 defines this variable without HAVE_HARDLOCKUP_DETECTOR_ARCH.
- It is the last arch-specific implementation which was developed before
- adding the common infrastructure for handling hardlockup detectors.
- It is always built. It does _not_ use the common command line
- parameters and sysctl interface, except for
- /proc/sys/kernel/nmi_watchdog.
-
config HAVE_HARDLOCKUP_DETECTOR_ARCH
bool
- select HAVE_NMI_WATCHDOG
help
The arch provides its own hardlockup detector implementation instead
of the generic ones.
@@ -424,9 +409,6 @@ config HAVE_HARDLOCKUP_DETECTOR_ARCH
It uses the same command line parameters, and sysctl interface,
as the generic hardlockup detectors.
- HAVE_NMI_WATCHDOG is selected to build the code shared with
- the sparc64 specific implementation.
-
config HAVE_PERF_REGS
bool
help
diff --git a/arch/sparc/Kconfig b/arch/sparc/Kconfig
index 8535e19062f6..7297f69635cb 100644
--- a/arch/sparc/Kconfig
+++ b/arch/sparc/Kconfig
@@ -33,7 +33,7 @@ config SPARC
select ARCH_WANT_IPC_PARSE_VERSION
select GENERIC_PCI_IOMAP
select HAS_IOPORT
- select HAVE_NMI_WATCHDOG if SPARC64
+ select HAVE_HARDLOCKUP_DETECTOR_SPARC64 if SPARC64
select HAVE_CBPF_JIT if SPARC32
select HAVE_EBPF_JIT if SPARC64
select HAVE_DEBUG_BUGVERBOSE
diff --git a/arch/sparc/Kconfig.debug b/arch/sparc/Kconfig.debug
index 6b2bec1888b3..4903b6847e43 100644
--- a/arch/sparc/Kconfig.debug
+++ b/arch/sparc/Kconfig.debug
@@ -14,3 +14,12 @@ config FRAME_POINTER
bool
depends on MCOUNT
default y
+
+config HAVE_HARDLOCKUP_DETECTOR_SPARC64
+ depends on HAVE_NMI
+ bool
+ help
+ Sparc64 hardlockup detector is the last one developed before adding
+ the common infrastructure for handling hardlockup detectors. It is
+ always built. It does _not_ use the common command line parameters
+ and sysctl interface, except for /proc/sys/kernel/nmi_watchdog.
diff --git a/include/linux/nmi.h b/include/linux/nmi.h
index b9e816bde14a..7ee6c35d1f05 100644
--- a/include/linux/nmi.h
+++ b/include/linux/nmi.h
@@ -9,7 +9,7 @@
#include <asm/irq.h>
/* Arch specific watchdogs might need to share extra watchdog-related APIs. */
-#if defined(CONFIG_HAVE_NMI_WATCHDOG)
+#if defined(CONFIG_HAVE_HARDLOCKUP_DETECTOR_ARCH) || defined(CONFIG_HAVE_HARDLOCKUP_DETECTOR_SPARC64)
#include <asm/nmi.h>
#endif
@@ -92,8 +92,7 @@ static inline void hardlockup_detector_disable(void) {}
#endif
/* Sparc64 has special implemetantion that is always enabled. */
-#if defined(CONFIG_HARDLOCKUP_DETECTOR) || \
- (defined(CONFIG_HAVE_NMI_WATCHDOG) && !defined(CONFIG_HAVE_HARDLOCKUP_DETECTOR_ARCH))
+#if defined(CONFIG_HARDLOCKUP_DETECTOR) || defined(CONFIG_HAVE_HARDLOCKUP_DETECTOR_SPARC64)
void arch_touch_nmi_watchdog(void);
#else
static inline void arch_touch_nmi_watchdog(void) { }
diff --git a/kernel/watchdog.c b/kernel/watchdog.c
index 437c198933cf..babd2f3c8b72 100644
--- a/kernel/watchdog.c
+++ b/kernel/watchdog.c
@@ -29,7 +29,7 @@
static DEFINE_MUTEX(watchdog_mutex);
-#if defined(CONFIG_HARDLOCKUP_DETECTOR) || defined(CONFIG_HAVE_NMI_WATCHDOG)
+#if defined(CONFIG_HARDLOCKUP_DETECTOR) || defined(CONFIG_HAVE_HARDLOCKUP_DETECTOR_SPARC64)
# define WATCHDOG_HARDLOCKUP_DEFAULT 1
#else
# define WATCHDOG_HARDLOCKUP_DEFAULT 0
diff --git a/lib/Kconfig.debug b/lib/Kconfig.debug
index a0b0c4decb89..e94664339e28 100644
--- a/lib/Kconfig.debug
+++ b/lib/Kconfig.debug
@@ -1050,15 +1050,10 @@ config HAVE_HARDLOCKUP_DETECTOR_BUDDY
# sparc64: has a custom implementation which is not using the common
# hardlockup command line options and sysctl interface.
#
-# Note that HAVE_NMI_WATCHDOG is used to distinguish the sparc64 specific
-# implementaion. It is automatically enabled also for other arch-specific
-# variants which set HAVE_HARDLOCKUP_DETECTOR_ARCH. It makes the check
-# of avaialable and supported variants quite tricky.
-#
config HARDLOCKUP_DETECTOR
bool "Detect Hard Lockups"
- depends on DEBUG_KERNEL && !S390
- depends on ((HAVE_HARDLOCKUP_DETECTOR_PERF || HAVE_HARDLOCKUP_DETECTOR_BUDDY) && !HAVE_NMI_WATCHDOG) || HAVE_HARDLOCKUP_DETECTOR_ARCH
+ depends on DEBUG_KERNEL && !S390 && !HAVE_HARDLOCKUP_DETECTOR_SPARC64
+ depends on HAVE_HARDLOCKUP_DETECTOR_PERF || HAVE_HARDLOCKUP_DETECTOR_BUDDY || HAVE_HARDLOCKUP_DETECTOR_ARCH
imply HARDLOCKUP_DETECTOR_PERF
imply HARDLOCKUP_DETECTOR_BUDDY
select LOCKUP_DETECTOR
@@ -1079,7 +1074,7 @@ config HARDLOCKUP_DETECTOR_PREFER_BUDDY
bool "Prefer the buddy CPU hardlockup detector"
depends on HARDLOCKUP_DETECTOR
depends on HAVE_HARDLOCKUP_DETECTOR_PERF && HAVE_HARDLOCKUP_DETECTOR_BUDDY
- depends on !HAVE_NMI_WATCHDOG
+ depends on !HAVE_HARLOCKUP_DETECTOR_ARCH
help
Say Y here to prefer the buddy hardlockup detector over the perf one.
@@ -1095,7 +1090,7 @@ config HARDLOCKUP_DETECTOR_PERF
bool
depends on HARDLOCKUP_DETECTOR
depends on HAVE_HARDLOCKUP_DETECTOR_PERF && !HARDLOCKUP_DETECTOR_PREFER_BUDDY
- depends on !HAVE_NMI_WATCHDOG
+ depends on !HAVE_HARDLOCKUP_DETECTOR_ARCH
select HARDLOCKUP_DETECTOR_COUNTS_HRTIMER
config HARDLOCKUP_DETECTOR_BUDDY
@@ -1103,7 +1098,7 @@ config HARDLOCKUP_DETECTOR_BUDDY
depends on HARDLOCKUP_DETECTOR
depends on HAVE_HARDLOCKUP_DETECTOR_BUDDY
depends on !HAVE_HARDLOCKUP_DETECTOR_PERF || HARDLOCKUP_DETECTOR_PREFER_BUDDY
- depends on !HAVE_NMI_WATCHDOG
+ depends on !HAVE_HARDLOCKUP_DETECTOR_ARCH
select HARDLOCKUP_DETECTOR_COUNTS_HRTIMER
#
--
2.35.3
More information about the Linuxppc-dev
mailing list