[PATCH v2 15/44] acpi_idle: Remove tracing

[Peter Zijlstra]

All the idle routines are called with RCU disabled, as such there must
not be any tracing inside.

While there; clean-up the io-port idle thing.

Signed-off-by: Peter Zijlstra (Intel) <peterz at infradead.org>
---
 drivers/acpi/processor_idle.c |   24 +++++++++++++-----------
 1 file changed, 13 insertions(+), 11 deletions(-)

--- a/drivers/acpi/processor_idle.c
+++ b/drivers/acpi/processor_idle.c
@@ -108,8 +108,8 @@ static const struct dmi_system_id proces
 static void __cpuidle acpi_safe_halt(void)
 {
 	if (!tif_need_resched()) {
-		safe_halt();
-		local_irq_disable();
+		raw_safe_halt();
+		raw_local_irq_disable();
 	}
 }
 
@@ -524,16 +524,21 @@ static int acpi_idle_bm_check(void)
 	return bm_status;
 }
 
-static void wait_for_freeze(void)
+static __cpuidle void io_idle(unsigned long addr)
 {
+	/* IO port based C-state */
+	inb(addr);
+
 #ifdef	CONFIG_X86
 	/* No delay is needed if we are in guest */
 	if (boot_cpu_has(X86_FEATURE_HYPERVISOR))
 		return;
 #endif
-	/* Dummy wait op - must do something useless after P_LVL2 read
-	   because chipsets cannot guarantee that STPCLK# signal
-	   gets asserted in time to freeze execution properly. */
+	/*
+	 * Dummy wait op - must do something useless after P_LVL2 read
+	 * because chipsets cannot guarantee that STPCLK# signal
+	 * gets asserted in time to freeze execution properly.
+	 */
 	inl(acpi_gbl_FADT.xpm_timer_block.address);
 }
 
@@ -553,9 +558,7 @@ static void __cpuidle acpi_idle_do_entry
 	} else if (cx->entry_method == ACPI_CSTATE_HALT) {
 		acpi_safe_halt();
 	} else {
-		/* IO port based C-state */
-		inb(cx->address);
-		wait_for_freeze();
+		io_idle(cx->address);
 	}
 
 	perf_lopwr_cb(false);
@@ -577,8 +580,7 @@ static int acpi_idle_play_dead(struct cp
 		if (cx->entry_method == ACPI_CSTATE_HALT)
 			safe_halt();
 		else if (cx->entry_method == ACPI_CSTATE_SYSTEMIO) {
-			inb(cx->address);
-			wait_for_freeze();
+			io_idle(cx->address);
 		} else
 			return -ENODEV;