[PATCH] i2c: pasemi: Wait for write xfers to finish

[Martin Povišer]

Wait for completion of write transfers before returning from the driver.
At first sight it may seem advantageous to leave write transfers queued
for the controller to carry out on its own time, but there's a couple of
issues with it:

 * Driver doesn't check for FIFO space.

 * The queued writes can complete while the driver is in its I2C read
   transfer path which means it will get confused by the raising of
   XEN (the 'transaction ended' signal). This can cause a spurious
   ENODATA error due to premature reading of the MRXFIFO register.

Adding the wait fixes some unreliability issues with the driver. There's
some efficiency cost to it (especially with pasemi_smb_waitready doing
its polling), but that will be alleviated once the driver receives
interrupt support.

Fixes: beb58aa39e6e ("i2c: PA Semi SMBus driver")
Signed-off-by: Martin Povišer <povik+lin at cutebit.org>
---

Tested on Apple's t8103 chip. To my knowledge the PA Semi controller
in its pre-Apple occurences behaves the same as far as this patch is
concerned.

 drivers/i2c/busses/i2c-pasemi-core.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/i2c/busses/i2c-pasemi-core.c b/drivers/i2c/busses/i2c-pasemi-core.c
index 7728c8460dc0..9028ffb58cc0 100644
--- a/drivers/i2c/busses/i2c-pasemi-core.c
+++ b/drivers/i2c/busses/i2c-pasemi-core.c
@@ -137,6 +137,12 @@ static int pasemi_i2c_xfer_msg(struct i2c_adapter *adapter,
 
 		TXFIFO_WR(smbus, msg->buf[msg->len-1] |
 			  (stop ? MTXFIFO_STOP : 0));
+
+		if (stop) {
+			err = pasemi_smb_waitready(smbus);
+			if (err)
+				goto reset_out;
+		}
 	}
 
 	return 0;
-- 
2.33.0