[PATCH] powerpc/fsl-pci: Fix Class Code of PCIe Root Port

Bjorn Helgaas helgaas at kernel.org
Sat Jul 23 05:42:26 AEST 2022


On Wed, Jul 06, 2022 at 12:10:43PM +0200, Pali Rohár wrote:
> By default old pre-3.0 Freescale PCIe controllers reports invalid PCI Class
> Code 0x0b20 for PCIe Root Port. It can be seen by lspci -b output on P2020
> board which has this pre-3.0 controller:
> 
>   $ lspci -bvnn
>   00:00.0 Power PC [0b20]: Freescale Semiconductor Inc P2020E [1957:0070] (rev 21)
>           !!! Invalid class 0b20 for header type 01
>           Capabilities: [4c] Express Root Port (Slot-), MSI 00
> 
> Fix this issue by programming correct PCI Class Code 0x0604 for PCIe Root
> Port to the Freescale specific PCIe register 0x474.
> 
> With this change lspci -b output is:
> 
>   $ lspci -bvnn
>   00:00.0 PCI bridge [0604]: Freescale Semiconductor Inc P2020E [1957:0070] (rev 21) (prog-if 00 [Normal decode])
>           Capabilities: [4c] Express Root Port (Slot-), MSI 00
> 
> Without any "Invalid class" error. So class code was properly reflected
> into standard (read-only) PCI register 0x08.
> 
> Same fix is already implemented in U-Boot pcie_fsl.c driver in commit:
> http://source.denx.de/u-boot/u-boot/-/commit/d18d06ac35229345a0af80977a408cfbe1d1015b
> 
> Fix activated by U-Boot stay active also after booting Linux kernel.
> But boards which use older U-Boot version without that fix are affected and
> still require this fix.
> 
> So implement this class code fix also in kernel fsl_pci.c driver.
> 
> Cc: stable at vger.kernel.org
> Signed-off-by: Pali Rohár <pali at kernel.org>

I assume the powerpc folks will take care of this.

> ---
>  arch/powerpc/sysdev/fsl_pci.c | 8 ++++++++
>  arch/powerpc/sysdev/fsl_pci.h | 1 +
>  2 files changed, 9 insertions(+)
> 
> diff --git a/arch/powerpc/sysdev/fsl_pci.c b/arch/powerpc/sysdev/fsl_pci.c
> index 1011cfea2e32..bfbb8c8fc9aa 100644
> --- a/arch/powerpc/sysdev/fsl_pci.c
> +++ b/arch/powerpc/sysdev/fsl_pci.c
> @@ -521,6 +521,7 @@ int fsl_add_bridge(struct platform_device *pdev, int is_primary)
>  	struct resource rsrc;
>  	const int *bus_range;
>  	u8 hdr_type, progif;
> +	u32 class_code;
>  	struct device_node *dev;
>  	struct ccsr_pci __iomem *pci;
>  	u16 temp;
> @@ -594,6 +595,13 @@ int fsl_add_bridge(struct platform_device *pdev, int is_primary)
>  			PPC_INDIRECT_TYPE_SURPRESS_PRIMARY_BUS;
>  		if (fsl_pcie_check_link(hose))
>  			hose->indirect_type |= PPC_INDIRECT_TYPE_NO_PCIE_LINK;
> +		/* Fix Class Code to PCI_CLASS_BRIDGE_PCI_NORMAL for pre-3.0 controller */
> +		if (in_be32(&pci->block_rev1) < PCIE_IP_REV_3_0) {
> +			early_read_config_dword(hose, 0, 0, PCIE_FSL_CSR_CLASSCODE, &class_code);
> +			class_code &= 0xff;
> +			class_code |= PCI_CLASS_BRIDGE_PCI_NORMAL << 8;
> +			early_write_config_dword(hose, 0, 0, PCIE_FSL_CSR_CLASSCODE, class_code);
> +		}
>  	} else {
>  		/*
>  		 * Set PBFR(PCI Bus Function Register)[10] = 1 to
> diff --git a/arch/powerpc/sysdev/fsl_pci.h b/arch/powerpc/sysdev/fsl_pci.h
> index cdbde2e0c96e..093a875d7d1e 100644
> --- a/arch/powerpc/sysdev/fsl_pci.h
> +++ b/arch/powerpc/sysdev/fsl_pci.h
> @@ -18,6 +18,7 @@ struct platform_device;
>  
>  #define PCIE_LTSSM	0x0404		/* PCIE Link Training and Status */
>  #define PCIE_LTSSM_L0	0x16		/* L0 state */
> +#define PCIE_FSL_CSR_CLASSCODE	0x474	/* FSL GPEX CSR */
>  #define PCIE_IP_REV_2_2		0x02080202 /* PCIE IP block version Rev2.2 */
>  #define PCIE_IP_REV_3_0		0x02080300 /* PCIE IP block version Rev3.0 */
>  #define PIWAR_EN		0x80000000	/* Enable */
> -- 
> 2.20.1
> 


More information about the Linuxppc-dev mailing list