[PATCH v4 19/25] PCI/DPC: Use PCI_POSSIBLE_ERROR() to check read from hardware

Naveen Naidu naveennaidu479 at gmail.com
Fri Nov 19 01:03:29 AEDT 2021


An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error.  There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use PCI_POSSIBLE_ERROR() to check the response we get when we read
data from hardware.

This helps unify PCI error response checking and make error checks
consistent and easier to find.

Compile tested only.

Signed-off-by: Naveen Naidu <naveennaidu479 at gmail.com>
---
 drivers/pci/pcie/dpc.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pci/pcie/dpc.c b/drivers/pci/pcie/dpc.c
index c556e7beafe3..3e9afee02e8d 100644
--- a/drivers/pci/pcie/dpc.c
+++ b/drivers/pci/pcie/dpc.c
@@ -79,7 +79,7 @@ static bool dpc_completed(struct pci_dev *pdev)
 	u16 status;
 
 	pci_read_config_word(pdev, pdev->dpc_cap + PCI_EXP_DPC_STATUS, &status);
-	if ((status != 0xffff) && (status & PCI_EXP_DPC_STATUS_TRIGGER))
+	if ((!PCI_POSSIBLE_ERROR(status)) && (status & PCI_EXP_DPC_STATUS_TRIGGER))
 		return false;
 
 	if (test_bit(PCI_DPC_RECOVERING, &pdev->priv_flags))
@@ -312,7 +312,7 @@ static irqreturn_t dpc_irq(int irq, void *context)
 
 	pci_read_config_word(pdev, cap + PCI_EXP_DPC_STATUS, &status);
 
-	if (!(status & PCI_EXP_DPC_STATUS_INTERRUPT) || status == (u16)(~0))
+	if (!(status & PCI_EXP_DPC_STATUS_INTERRUPT) || PCI_POSSIBLE_ERROR(status))
 		return IRQ_NONE;
 
 	pci_write_config_word(pdev, cap + PCI_EXP_DPC_STATUS,
-- 
2.25.1



More information about the Linuxppc-dev mailing list