Errant readings on LM81 with T2080 SoC

Chris Packham Chris.Packham at alliedtelesis.co.nz
Mon Mar 8 13:27:08 AEDT 2021


On 8/03/21 1:31 pm, Guenter Roeck wrote:
> On 3/7/21 2:52 PM, Chris Packham wrote:
>> Hi,
>>
>> I've got a system using a PowerPC T2080 SoC and among other things has
>> an LM81 hwmon chip.
>>
>> Under a high CPU load we see errant readings from the LM81 as well as
>> actual failures. It's the errant readings that cause the most concern
>> since we can easily ignore the read errors in our monitoring application
>> (although it would be better if they weren't there at all).
>>
>> I'm able to reproduce this with a test application[0] that artificially
>> creates a high CPU load then by repeatedly checking for the all-1s
>> values from the LM81 datasheet[1](page 17). The all-1s readings stick
>> out as they are obviously higher than the voltage rails that are
>> connected and disagree with measurements taken with a multimeter.
>>
>> Here's the output from my device
>>
>> [root at linuxbox ~]# cpuload 90&
>> [root at linuxbox ~]# (while true; do cat /sys/class/hwmon/hwmon0/in*_input
>> | grep '3320\|4383\|6641\|15930\|3586'; sleep 1; done)&
>> 3586
>> 3586
>> cat: read error: No such device or address
>> cat: read error: No such device or address
>> 3320
>> 3320
>> 3586
>> 3586
>> 6641
>> 6641
>> 4383
>> 4383
>>
>> Fundamentally I think this is a problem with the fact that the LM81 is
>> an SMBus device but the T2080 (and other Freescale SoCs) uses i2c and we
>> emulate SMBus. I suspect the errant readings are when we don't get round
>> to completing the read within the timeout specified by the SMBus
>> specification. Depending on when that happens we either fail the
>> transfer or interpret the result as all-1s.
>>
> That is quite unlikely. Many sensor chips are SMBus chips connected to
> i2c busses. It is much more likely that there is a bug in the T2080 i2c driver,
> that the chip doesn't like the bulk read command issued through regmap, that
> the chip has problems with the i2c bus speed, or that the i2c bus is noisy.
Perhaps something gets upset when interrupt processing is delayed 
because of CPU load. I don't see the problem when there isn't a CPU load 
so I think that eliminates board issues.
> In this context, the "No such device or address" responses are very suspicious.
> Those are reported by the i2c driver, not by the hwmon driver, and suggest
> that the chip did not respond to a read request. Maybe it helps to enable
> debugging to the i2c driver to see if it reports anything useful. Even
> better might be to connect an i2c bus analyzer to the i2c bus and check
> what is going on.
That's from -ENXIO which is used in only one place in i2c-mpc.c. I'll 
enable some debug and see what we get.
>
> Guenter


More information about the Linuxppc-dev mailing list