[PATCH 1/1] powerpc/smp: Set numa node before updating mask

[Srikar Dronamraju]

* Nathan Lynch <nathanl at linux.ibm.com> [2021-04-07 07:19:10]:

> Sorry for the delay in following up here.
> 

No issues.

> >> So I'd suggest that pseries_add_processor() be made to update
> >> these things when the CPUs are marked present, before onlining them.
> >
> > In pseries_add_processor, we are only marking the cpu as present. i.e
> > I believe numa_setup_cpu() would not have been called. So we may not have a
> > way to associate the CPU to the node. Otherwise we will have to call
> > numa_setup_cpu() or the hcall_vphn.
> >
> > We could try calling numa_setup_cpu() immediately after we set the
> > CPU to be present, but that would be one more extra hcall + I dont know if
> > there are any more steps needed before CPU being made present and
> > associating the CPU to the node.
> 
> An additional hcall in this path doesn't seem too expensive.
> 
> > Are we sure the node is already online?
> 
> I see that dlpar_online_cpu() calls find_and_online_cpu_nid(), so yes I
> think that's covered.

Okay, 

Can we just call set_cpu_numa_node() at the end of map_cpu_to_node().
The advantage would be the update to numa_cpu_lookup_table and cpu_to_node
would happen at the same time and would be in sync.

-- 
Thanks and Regards
Srikar Dronamraju