[PATCH 0/8] Improve signal performance on PPC64 with KUAP

[Christopher M. Riedl]

As reported by Anton, there is a large penalty to signal handling
performance on radix systems using KUAP. The signal handling code
performs many user access operations, each of which needs to switch the
KUAP permissions bit to open and then close user access. This involves a
costly 'mtspr' operation [0].

There is existing work done on x86 and by Christopher Leroy for PPC32 to
instead open up user access in "blocks" using user_*_access_{begin,end}.
We can do the same in PPC64 to bring performance back up on KUAP-enabled
radix systems.

This series applies on top of Christophe Leroy's work for PPC32 [1] (I'm
sure patchwork won't be too happy about that).

The first two patches add some needed 'unsafe' versions of copy-from
functions. While these do not make use of asm-goto they still allow for
avoiding the repeated uaccess switches. The third patch adds 'notrace'
to any functions expected to be called in a uaccess block context.
Normally functions called in such a context should be inlined, but this
is not feasible everywhere. Marking them 'notrace' should provide _some_
protection against leaving the user access window open.

The next three patches rewrite some of the signal64 helper functions to
be 'unsafe'. Finally, the last two patches update the main signal
handling functions to make use of the new 'unsafe' helpers and eliminate
some additional uaccess switching.

I used the will-it-scale signal1 benchmark to measure and compare
performance [2]. The below results are from a P9 Blackbird system. Note
that currently hash does not support KUAP and is therefore used as the
"baseline" comparison. Bigger numbers are better:

	signal1_threads -t1 -s10

	|                 | hash   | radix  |
	| --------------- | ------ | ------ |
	| linuxppc/next   | 289014 | 158408 |
	| unsafe-signal64 | 298506 | 253053 |

[0]: https://github.com/linuxppc/issues/issues/277
[1]: https://patchwork.ozlabs.org/project/linuxppc-dev/list/?series=196278
[2]: https://github.com/antonblanchard/will-it-scale/blob/master/tests/signal1.c

Christopher M. Riedl (5):
  powerpc/uaccess: Add unsafe_copy_from_user
  powerpc/signal: Add unsafe_copy_{vsx,fpr}_from_user()
  powerpc: Mark functions called inside uaccess blocks w/ 'notrace'
  powerpc/signal64: Replace setup_sigcontext() w/
    unsafe_setup_sigcontext()
  powerpc/signal64: Replace restore_sigcontext() w/
    unsafe_restore_sigcontext()

Daniel Axtens (3):
  powerpc/signal64: Replace setup_trampoline() w/
    unsafe_setup_trampoline()
  powerpc/signal64: Rewrite handle_rt_signal64() to minimise uaccess
    switches
  powerpc/signal64: Rewrite rt_sigreturn() to minimise uaccess switches

 arch/powerpc/include/asm/uaccess.h |  28 ++--
 arch/powerpc/kernel/process.c      |  20 +--
 arch/powerpc/kernel/signal.h       |  33 +++++
 arch/powerpc/kernel/signal_64.c    | 216 +++++++++++++++++------------
 arch/powerpc/mm/mem.c              |   4 +-
 5 files changed, 194 insertions(+), 107 deletions(-)

-- 
2.28.0