[PATCH] powerpc/book3s64/radix: Add kernel command line option to disable radix GTSE

[Bharata B Rao]

On Fri, Jul 24, 2020 at 01:26:00PM +0530, Aneesh Kumar K.V wrote:
> This adds a kernel command line option that can be used to disable GTSE support.
> Disabling GTSE implies kernel will make hcalls to invalidate TLB entries.
> 
> This was done so that we can do VM migration between configs that enable/disable
> GTSE support via hypervisor. To migrate a VM from a system that supports
> GTSE to a system that doesn't, we can boot the guest with radix_gtse=off, thereby
> forcing the guest to use hcalls for TLB invalidates.
> 
> The check for hcall availability is done in pSeries_setup_arch so that
> the panic message appears on the console. This should only happen on
> a hypervisor that doesn't force the guest to hash translation even
> though it can't handle the radix GTSE=0 request via CAS. With radix_gtse=off
> if the hypervisor doesn't support hcall_rpt_invalidate hcall it should
> force the LPAR to hash translation.
> 
> Signed-off-by: Aneesh Kumar K.V <aneesh.kumar at linux.ibm.com>
> ---
>  Documentation/admin-guide/kernel-parameters.txt |  3 +++
>  arch/powerpc/include/asm/firmware.h             |  4 +++-
>  arch/powerpc/kernel/prom_init.c                 | 13 +++++++++----
>  arch/powerpc/platforms/pseries/firmware.c       |  1 +
>  arch/powerpc/platforms/pseries/setup.c          |  5 +++++
>  5 files changed, 21 insertions(+), 5 deletions(-)
 
Tested

1. radix_gtse=off with KVM implementation of H_RPT_INVALIDATE hcall, the
   tlb flush calls get off-loaded to hcalls.
2. radix_gtse=off w/o H_RPT_INVALIDATE hcall, the guest kernel panics
   as per design.

However in both cases, the guest kernel prints out
"WARNING: Hypervisor doesn't support RADIX with GTSE" which can be a bit
confusing in case 1 as GTSE has disabled by the guest and hypervisor is
capable of supporting the same via hcall.

Regards,
Bharata.