[PATCH v3 03/12] powerpc/kexec_file: add helper functions for getting memory ranges

[Hari Bathini]

On 15/07/20 5:19 am, Thiago Jung Bauermann wrote:
> 
> Hello Hari,
> 
> Hari Bathini <hbathini at linux.ibm.com> writes:
> 
>> In kexec case, the kernel to be loaded uses the same memory layout as
>> the running kernel. So, passing on the DT of the running kernel would
>> be good enough.
>>
>> But in case of kdump, different memory ranges are needed to manage
>> loading the kdump kernel, booting into it and exporting the elfcore
>> of the crashing kernel. The ranges are exlude memory ranges, usable
> 
> s/exlude/exclude/
> 
>> memory ranges, reserved memory ranges and crash memory ranges.
>>
>> Exclude memory ranges specify the list of memory ranges to avoid while
>> loading kdump segments. Usable memory ranges list the memory ranges
>> that could be used for booting kdump kernel. Reserved memory ranges
>> list the memory regions for the loading kernel's reserve map. Crash
>> memory ranges list the memory ranges to be exported as the crashing
>> kernel's elfcore.
>>
>> Add helper functions for setting up the above mentioned memory ranges.
>> This helpers facilitate in understanding the subsequent changes better
>> and make it easy to setup the different memory ranges listed above, as
>> and when appropriate.
>>
>> Signed-off-by: Hari Bathini <hbathini at linux.ibm.com>
>> Tested-by: Pingfan Liu <piliu at redhat.com>
> 

<snip>

>> +/**
>> + * add_reserved_ranges - Adds "/reserved-ranges" regions exported by f/w
>> + *                       to the given memory ranges list.
>> + * @mem_ranges:          Range list to add the memory ranges to.
>> + *
>> + * Returns 0 on success, negative errno on error.
>> + */
>> +int add_reserved_ranges(struct crash_mem **mem_ranges)
>> +{
>> +	int i, len, ret = 0;
>> +	const __be32 *prop;
>> +
>> +	prop = of_get_property(of_root, "reserved-ranges", &len);
>> +	if (!prop)
>> +		return 0;
>> +
>> +	/*
>> +	 * Each reserved range is an (address,size) pair, 2 cells each,
>> +	 * totalling 4 cells per range.
> 
> Can you assume that, or do you need to check the #address-cells and
> #size-cells properties of the root node?

Taken from early_reserve_mem_dt() which did not seem to care.
Should we be doing any different here?

Thanks
Hari