[PATCH] powerpc/eeh: Only dump stack once if an MMIO loop is detected

[Oliver O'Halloran]

Many drivers don't check for errors when they get a 0xFFs response from an
MMIO load. As a result after an EEH event occurs a driver can get stuck in
a polling loop unless it some kind of internal timeout logic.

Currently EEH tries to detect and report stuck drivers by dumping a stack
trace after eeh_dev_check_failure() is called EEH_MAX_FAILS times on an
already frozen PE. The value of EEH_MAX_FAILS was chosen so that a dump
would occur every few seconds if the driver was spinning in a loop. This
results in a lot of spurious stack traces in the kernel log.

Fix this by limiting it to printing one stack trace for each PE freeze. If
the driver is truely stuck the kernel's hung task detector is better suited
to reporting the probelm anyway.

Cc: Sam Bobroff <sbobroff at linux.ibm.com>
Signed-off-by: Oliver O'Halloran <oohall at gmail.com>
---
 arch/powerpc/kernel/eeh.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/powerpc/kernel/eeh.c b/arch/powerpc/kernel/eeh.c
index bc8a551013be..c35069294ecf 100644
--- a/arch/powerpc/kernel/eeh.c
+++ b/arch/powerpc/kernel/eeh.c
@@ -503,7 +503,7 @@ int eeh_dev_check_failure(struct eeh_dev *edev)
 	rc = 1;
 	if (pe->state & EEH_PE_ISOLATED) {
 		pe->check_count++;
-		if (pe->check_count % EEH_MAX_FAILS == 0) {
+		if (pe->check_count == EEH_MAX_FAILS) {
 			dn = pci_device_to_OF_node(dev);
 			if (dn)
 				location = of_get_property(dn, "ibm,loc-code",
-- 
2.21.0