[PATCH] net/ibmvnic: Fix EOI when running in XIVE mode.

[Cédric Le Goater]

pSeries machines on POWER9 processors can run with the XICS (legacy)
interrupt mode or with the XIVE exploitation interrupt mode. These
interrupt contollers have different interfaces for interrupt
management : XICS uses hcalls and XIVE loads and stores on a page.
H_EOI being a XICS interface the enable_scrq_irq() routine can fail
when the machine runs in XIVE mode.

Fix that by calling the EOI handler of the interrupt chip.

Fixes: f23e0643cd0b ("ibmvnic: Clear pending interrupt after device reset")
Signed-off-by: Cédric Le Goater <clg at kaod.org>
---
 drivers/net/ethernet/ibm/ibmvnic.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/ibm/ibmvnic.c b/drivers/net/ethernet/ibm/ibmvnic.c
index 2b073a3c0b84..f59d9a8e35e2 100644
--- a/drivers/net/ethernet/ibm/ibmvnic.c
+++ b/drivers/net/ethernet/ibm/ibmvnic.c
@@ -2878,12 +2878,10 @@ static int enable_scrq_irq(struct ibmvnic_adapter *adapter,
 
 	if (test_bit(0, &adapter->resetting) &&
 	    adapter->reset_reason == VNIC_RESET_MOBILITY) {
-		u64 val = (0xff000000) | scrq->hw_irq;
+		struct irq_desc *desc = irq_to_desc(scrq->irq);
+		struct irq_chip *chip = irq_desc_get_chip(desc);
 
-		rc = plpar_hcall_norets(H_EOI, val);
-		if (rc)
-			dev_err(dev, "H_EOI FAILED irq 0x%llx. rc=%ld\n",
-				val, rc);
+		chip->irq_eoi(&desc->irq_data);
 	}
 
 	rc = plpar_hcall_norets(H_VIOCTL, adapter->vdev->unit_address,
-- 
2.21.0