[PATCH v2 4/6] dt-bindings: soc/fsl: qe: document new fsl,qe-snums binding

Rasmus Villemoes rasmus.villemoes at prevas.dk
Wed May 1 19:29:08 AEST 2019


Reading table 4-30, and its footnotes, of the QUICC Engine Block
Reference Manual shows that the set of snum _values_ is not
necessarily just a function of the _number_ of snums, as given in the
fsl,qe-num-snums property.

As an alternative, to make it easier to add support for other variants
of the QUICC engine IP, this introduces a new binding fsl,qe-snums,
which automatically encodes both the number of snums and the actual
values to use.

For example, for the MPC8309, one would specify the property as

               fsl,qe-snums = /bits/ 8 <
                       0x88 0x89 0x98 0x99 0xa8 0xa9 0xb8 0xb9
                       0xc8 0xc9 0xd8 0xd9 0xe8 0xe9>;

Signed-off-by: Rasmus Villemoes <rasmus.villemoes at prevas.dk>
---
 Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
index d7afaff5faff..05f5f485562a 100644
--- a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
+++ b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe.txt
@@ -18,7 +18,8 @@ Required properties:
 - reg : offset and length of the device registers.
 - bus-frequency : the clock frequency for QUICC Engine.
 - fsl,qe-num-riscs: define how many RISC engines the QE has.
-- fsl,qe-num-snums: define how many serial number(SNUM) the QE can use for the
+- fsl,qe-snums: This property has to be specified as '/bits/ 8' value,
+  defining the array of serial number (SNUM) values for the virtual
   threads.
 
 Optional properties:
@@ -34,6 +35,11 @@ Recommended properties
 - brg-frequency : the internal clock source frequency for baud-rate
   generators in Hz.
 
+Deprecated properties
+- fsl,qe-num-snums: define how many serial number(SNUM) the QE can use
+  for the threads. Use fsl,qe-snums instead to not only specify the
+  number of snums, but also their values.
+
 Example:
      qe at e0100000 {
 	#address-cells = <1>;
-- 
2.20.1



More information about the Linuxppc-dev mailing list