[PATCH net] net/ibmvnic: Report last valid speed and duplex values to ethtool

[Thomas Falcon]

On 6/27/19 12:57 PM, Andrew Lunn wrote:
> On Thu, Jun 27, 2019 at 12:09:13PM -0500, Thomas Falcon wrote:
>> This patch resolves an issue with sensitive bonding modes
>> that require valid speed and duplex settings to function
>> properly. Currently, the adapter will report that device
>> speed and duplex is unknown if the communication link
>> with firmware is unavailable.
> Dumb question. If you cannot communicate with the firmware, isn't the
> device FUBAR? So setting the LACP port to disabled is the correct
> things to do.
>
>         Andrew
>
Yes, I think that is correct too.  The problem is that the link is only 
down temporarily.  In this case - we are testing with a pseries logical 
partition - the partition is migrated to another server. The driver must 
wait for a signal from the hypervisor to resume operation with the new 
device.  Once it resumes, we see that the device reboots and gets 
correct speed settings, but the port flag (AD_LACP_PORT_ENABLED) is 
still cleared.

Tom